Abstract:Shear-mode piezoelectric materials have been widely used to shunt the damping of vibrations where utilizing surface or interface shear stresses. The thick-shear mode (TSM) elastic constant and the mechanical loss factor can change correspondingly when piezoelectric materials are shunted to different electrical circuits. This phenomenon makes it possible to control the performance of a shear-mode piezoelectric damping system through designing the shunt circuit. However, due to the difficulties in directly measuring the TSM elastic constant and the mechanical loss factor of piezoelectric materials, the relationships between those parameters and the shunt circuits have rarely been investigated. In this paper, a coupling TSM electro–mechanical resonant system is proposed to indirectly measure the variations of the TSM elastic constant and the mechanical loss factor of piezoelectric materials. The main idea is to transform the variations of the TSM elastic constant and the mechanical loss factor into the changes of the easily observed resonant frequency and electrical quality factor of the coupling electro–mechanical resonator. Based on this model, the formular relationships are set up theoretically with Mason equivalent circuit method and they are validated with finite element (FE) analyses. Finally, a prototype of the coupling electro–mechanical resonator is fabricated with two shear-mode PZT5A plates to investigate the TSM elastic constants and the mechanical loss factors of different circuit-shunted cases of the piezoelectric plate. Both the resonant frequency shifts and the bandwidth changes observed in experiments are in good consistence with the theoretical and FE analyses under the same shunt conditions. The proposed coupling resonator and the obtained relationships are validated with but not limited to PZT5A.

The Development of a General Anisotropic Material Model with Resonant Ultrasound Spectroscopy Technology for the Measurement of Elastic Constants of Piezoelectric Crystals

Mathematical Modelling of One-Dimensional Piezoelectric Transducers Based on Monoclinic Crystals

Rapidly Measuring Elastic Coefficients of New Piezoelectric Materials Using Resonant Ultrasound Spectroscopy

Characterization of Piezoelectric Materials Using Ultrasonic and Resonant Techniques

Analysis of Longitudinal and Torsional Resonance Vibrations of a Piezoelectrically Excited Bar by Introducing Piezoelectric Loss Coefficients

Measurement of Solid Materials’ Young’s Modulus by Piezoelectric Resonance and ANSYS Simulation Method

An Original 2-D Analytical Model for Investigating Coupled Vibrations of Finite Piezoelectric Resonators

Characterizing Full Matrix Constants Of Piezoelectric Single Crystals With Strong Anisotropy Using Two Samples

High-Damping Viscoelastic Material Monitoring Using Sub-Resonator Enhanced Electro-Mechanical Impedance Spectroscopy

Theoretical Analysis of Quartz Plate Acoustic Wave Resonators and Sensors Using Three-Dimensional Equations of Anisotropic Elasticity or Piezoelectricity

Resonant ultrasound spectroscopy applications: Elastic moduli computation with x-ray computed tomography input for irregularly shaped objects

Health Monitoring of High-Damping Viscoelastic Materials Using Sub-Resonator Enriched Electro-Mechanical Impedance Signatures

Determination of Full Set Material Constants of Piezoceramics from Phase Velocities

An Accurate Method for the Determination of Complex Coefficients of Single Crystal Piezoelectric Resonators II: Design of Measurement and Experiments

Modeling and characterizing the dynamic response of Octet-Truss lattice structures using elastic parameters determined from Resonant Ultrasound Spectroscopy

Modeling of Acoustoelastic Effects Based on Anharmonic Atomic Interaction

Determining Full Matrix Constants of Piezoelectric Crystal From a Single Sample Using Partial Electrode Electromechanical Impedance Spectroscopy

Investigations of Thickness-Shear Mode Elastic Constant and Damping of Shunted Piezoelectric Materials with a Coupling Resonator

Development of an ultrasonic system to measure material elastic constants of small sample

Laser-induced Surface Acoustic Waves for Measurement of Elastic Constants Based on Mode Conversion

Numerical framework for anisotropic flexible piezoelectrics with large deformation