Abstract:High voltage (HV) outdoor insulators are subjected to both electrical and environmental stresses, which may lead to their failure. Among the causes, corona discharge, humidity and UV radiation are considered to be the most damaging factors. Efforts are therefore underway to investigate new materials for improving the performance of insulating systems. In this research work, silicone-based room temperature vulcanized samples filled with alumina trihydrate (ATH), silicon dioxide and magnesium hydroxide (MH) were prepared and exposed to AC corona discharge for a duration of 110 h. The electric discharge was also accompanied by UV radiation and two different humidity levels. Following aging of the test samples, diagnosis was conducted to assess their integrity. Measurements based on determining the static contact angle demonstrated the loss of hydrophobicity of all the materials, while hydrophobicity recovery phenomena revealed that ATH-doped materials demonstrated a comparatively higher increase in the contact angle than in samples filled with silicone dioxide (silica) and MH. Scanning electron microscopy analysis revealed deep cracks and block-like structures on their surfaces. Similarly, energy-dispersive X-ray analysis indicated the signs of surface oxidation of the aged samples. However, the data of elemental composition exhibited the loss of filler contents as well as that of carbon from the base matrix. The overall assessment showed that resistance to suppress aging is influenced by both the filler type and its concentration in the investigated composites. The ATH-filled composites exhibited outstanding performance when exposed to the rigors of corona discharge and other environmental stresses. This research contributes to materials science and HV engineering by addressing the development of composites for enhanced insulator performance, with future aspects lying in the utilization of nano-composites for advanced functionality and durability.

Analysis on Surface Characteristics of Composite Insulator Materials after Corona Discharge

Review in Application of High Voltage Composite Insulator and Its Ageing State

Experimental Investigation of Corona Discharge Performance Along the Surface of Composite Insulators

Influence of Surface Discharge on Resin Degradation in Decay-like Fracture of Composite Insulators.

Influence of AC Corona Discharge on Contamination Layer of Composite Insulator Surface

Analysis of a Fractured 500 Kv Composite Insulator - Identification of Aging Mechanisms and Their Causes

Composite Insulator Interface Discharge Accelerated Decay-Like Aging and Analysis

Analysis of Aging Characteristics of Umbrella Skirts of Composite Insulators Operating under the Influence of a Wind and Sand Environment in South Xinjiang

Evaluation of Electrical Insulation Properties on Aged Composite Insulators in Heavily Contaminated Areas

Study on the Aging Characteristics of a ±500 kV Composite Dead-End Insulator in Longtime Service

Fracture Fault Analysis and Aging Mechanism Study for 500 kV Composite Insulator

Research on Diagnostic Method of Plasma Caused by Corona Discharge on Top of Composite Insulator under Atmosphere Conditions

Surface Hardness Analysis of Aged Composite Insulators via Laser-Induced Plasma Spectra Characterization

Aging Effects of Conductor Surface Conditions on AC Corona Discharge

Intensification of Electric Field Stresses in Field Aged 380-kV Composite Insulators Due to Loss of Hydrophobicity

Influence of Aged Conductor Surface Conditions on AC Corona Discharge with a Corona Cage

Observation of Corona and Flashover on the Surface of Composite Insulators

Hydrophobicity Distribution Analysis of DC Composite Insulators

Investigation on Hydrophobicity and Pollution Status of Composite Insulators in Contaminated Areas

Aging Evaluation of Composite Insulator with Laser-induced Breakdown Spectroscopy

Aging assessment of silicone rubber materials under corona discharge accompanied by humidity and UV radiation