Abstract:A new non-isolated modified SEPIC front-end dc-dc converter for the low power system is proposed in this paper, and this converter is the next level of the traditional SEPIC converter with additional devices, such as two diodes and splitting of the output capacitor into two equal parts. The circuit topology proposed in this paper is formulated by combining the boost structure with the traditional SEPIC converter. Therefore, the proposed converter has the benefit of the SEPIC converter, such as continuous input current. The proposed circuit structure also improves the features, such as high voltage gain and high conversion efficiency. The converter comprises one MOSFET switch, one coupled inductor, three diodes, and two capacitors, including the output capacitor. The converter effectively recovers the leakage energy of the coupled inductor through the passive clamp circuit. The operation of the proposed converter is explained in continuous conduction mode (CCM) and discontinuous conduction mode (DCM). The required voltage gain of the converter can be acquired by adjusting the coupled inductor turn’s ratio along with the additional devices at less duty cycle of the switch. The simulation of the proposed converter under CCM is carried out, and an experimental prototype of 100 W, 25 V/200 V is made, and the experimental outcomes are presented to validate the theoretical discussions of the proposed converter. The operating performance of the proposed converter is compared with the converters discussed in the literature. The proposed converter can be extended by connecting voltage multiplier (VM) cell circuits to get the ultra-high voltage gain.

Digital assistant current sensor for PWM DC-DC converter with segmented output stage

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

A 750Ma,dual-Mode PWM/PFM Step-Down DC-DC Converter with High Efficiency

Real Time Zero Current Detection with Low Quiescent Current for Synchronous DC-DC Converter

An Adaptive Segment Output Stage for Pwm Dc-Dc Converter

PWM/PSM Dual-Mode Controller for High Efficiency DC-DC Buck Converter

Single-stage Power Factor Correction Converter with Coupled Input Current Shaping Inductor

High Frequency and High Efficiency DC-DC Converter with Sensorless Adaptive-Sizing Technique

A Digitally Controlled Pwm/Psm Dual-Mode Dc/Dc Converter

A High-Efficiency 12/1-V Dual-Path Series-Capacitor Converter with Low $v\cdot A$ Metric and Full Duty Range

An On-Chip High-Speed Current Sensor Applied in the Current-Mode DC–DC Converter

A DC-DC Converter with Switched-Capacitor Delay Deadtime Controller and Enhanced Unbalanced-Input Pair Zero-Current Detector to Boost Power Efficiency

A Large-Current, Highly Integrated Switched-Capacitor Divider with a Dual-Branch Interleaved Topology and Light Load Efficiency Improvement

A High-Efficiency Double Step Down Converter with Dual-Mode Control and Seamless Mode Transition in A Wide Load Current Range

Adaptive Switching Frequency Buck Dc-Dc Converter with High-Accuracy On- Chip Current Sensor

A monolithic CMOS synchronous Buck converter with a fast and low-cost current sensing scheme

A novel on-chip current-sensing structure for current-mode DC-DC converter

Considerations on the optimal power stage segmentation algorithm for MHz integrated synchronous Buck DC-DC converters

Current Estimation and Optimal Control in Multiphase DC–DC Converters With Single Current Sensor

An Optimized Auto-Tuning Digital Dc-Dc Converter Based on Linear-Non-Linear and Predictive Pid

Design and Development of Non-Isolated Modified SEPIC DC-DC Converter Topology for High-Step-Up Applications: Investigation and Hardware Implementation