Abstract:This paper presents a radio frequency (RF) triple pole triple throw 3P3T cross antenna switch for cellular mobile devices. The negative biasing scheme was applied to improve the power-handling capability and linearity of the switch by increasing the maximum tolerable voltage drop across the drain and source and reverse biasing the parasitic junction diodes. To avoid signal reflection through the antenna in off-state, all the antenna ports were equipped with 50-ohm termination to provide the pull-down path. Considering the simultaneous operation of antenna ports in different switch cases, the presented T-type pull-down path demonstrated improvement of isolation by over 15 dB. Using stacked switches, the 3P3T handled the input power level of over 35 dBm. The chip was manufactured in 65 nm complementary metal oxide semiconductor (CMOS) silicon on insulator (SOI) technology with a die size of 790 × 730 µm. The proposed structure achieved insertion loss, isolation, and voltage standing wave ratio (VSWR) of less than -0.9 dB, -40 dB, and 1.6, respectively, when the input signal was 3.8 GHz. The measured results prove the implemented switch shows the second and third harmonic distortion performances of less than -60 dBm when the input power level and frequency are 25 dBm and 3.8 GHz, respectively.

An Antenna Switch Module for GSM Application Using LTCC Technology

An antenna switch module for GSM application using LTCC technology

An LTCC duplexer for GSM/DCS applications

An novel integrated antenna switch for DCS/UMTS application

Monolithic MIPI SOI CMOS single-pole fourteen-throw antenna switch module with on-chip transmit filters for cellular handsets

A Switchable Dual-Band LNA with Simultaneous Noise and Input Impedance Matching for GSM/TD-SCDMA Applications

AN OVERALL LTCC PACKAGE SOLUTION FOR X-BAND TILE T/R MODULE

A high-isolation low-insertion-loss filter-integrated PIN diode antenna switch

A two-channel L-band GaAs MMIC LNA module for Satellite Application

AN 8 GHZ FRONT-END MODULE WITH HIGH-PERFORMANCE T/R SWITCH AND LNA

A Sub-6G SP32T Single-Chip Switch with Nanosecond Switching Speed for 5G Applications in 0.25 Μm GaAs Technology

A Switchable matching circuit for compact wideband antenna designs

Small-Size Coupled-Fed Antenna with Two Printed Distributed Inductors for Seven-Band WWAN/LTE Mobile Handset

A novel PIN switch diode integrating with 0.18um SiGe HBT BiCMOS process

Novel surface-mounted antenna with a chip capacitance embedded for LTE/WWAN wireless USB dongle applications

The Design of a 57-65Ghz SPDT Switch with LC Resonant Techniques in 40 Nm CMOS Process

A NEW DEFECTED GROUND STRUCTURE AND ITS APPLICATION FOR MINIATURIZED SWITCHABLE ANTENNA

Design of Low Loss Ka-Band SPDT Switch Based on AlGaN/GaN HEMT Technology

A LTCC - Based Flat Dual - Polarized Long - Slot Array Antenna for Millimeter - Wave Applications

Printed Slot Antenna for Seven-Band GSM/UMTS/LTE Operation in the Internal Mobile Phone

A High-Power 3P3T Cross Antenna Switch with Low Harmonic Distortion and Enhanced Isolation Using T-Type Pull-Down Path for Cellular Mobile Devices