Abstract:Removing the gearbox from the single-motor configuration of an electric vehicle (EV) would improve motor-to-wheel efficiency by preventing mechanical losses, thus extending the autonomy of the EV. To this end, a permanent-magnet Vernier machine (PMVM) is designed to ensure such operation. This machine avoids the high volume and large pole-pair number of the armature winding since its operating principle resembles that of a synchronous machine with an integrated magnetic gear. Therefore, such a structure achieves low-speed and high-torque operation at standard supply frequencies. From the specification of an urban vehicle, the required specification for direct-drive operation is first determined. On this basis, an initial prototype of a Vernier Machine with permanent magnets in the rotor that can replace the traction part (motor + gearbox) is designed and sized. This first prototype uses radial contiguous surface-mounted magnets and its performance is then analyzed using finite element analysis (FEA), showing a relatively high torque ripple ratio. The rotor magnets are then arranged in a quasi-Halbach configuration and simulations are performed with different stator slot openings and different ratios of the tangential part of the magnet in order to quantify the effect of each of these two quantities in terms of average torque, torque ripples and harmonics of the back-electromotive force at no load. Since the design and optimization of this motor is finite element-assisted, a coupling process between FEA Flux software and Altair HyperStudy is implemented for optimization. This method has the advantages of high accuracy of the magnetic flux densities and electromagnetic torque estimates, and especially the torque ripples. The optimization process leads to a prototype with an average torque value that meets the specification, along with a torque ripple ratio below 5% and a high power factor, while keeping the same amount of magnet and copper.

Design, modelling and testing of a high speed induction machine drive

Performance Analysis of DC-Biased Modular Linear Variable Flux Reluctance Machines

Challenges of the Optimization of a High-Speed Induction Machine for Naval Applications

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

Design, Analysis and Experimental Evaluation of a Novel High-Speed High-Power Ferrite IPM Machine for Traction Applications

Design and Analysis of a 500W 120000rpm High-Speed Permanent Magnet Motor

Performance Entitlement by Using Novel High Strength Electrical Steels and Copper Alloys for High-Speed Laminated Rotor Induction Machines

Optimization Design of Linear Induction Motor and Study of the 3-Phase Asymmetry Phenomenon

Robust Design of Induction Machines for High-Speed Electric Freight Locomotive Applications

High-speed Permanent Magnet Electrical Machines — Applications, Key Issues and Challenges

Design Optimization of Multi-Layer Permanent Magnet Synchronous Machines for Electric Vehicle Applications

Mechanical Design and Analysis of a High-Torque Modular Hybrid Excitation Synchronous Machine for Electric Vehicle Propulsion Applications

Design and Electromagnetic Simulation of High Speed PERMANENT Magnet Synchronous Motor

Analysis and Design of an Electric Machine Employing a Special Stator With Phase Winding Modules and PMs and a Reluctance Rotor

A Novel DC-Biased Phase Current-Independent Drive High-Speed Vernier Reluctance Machine

Modeling and Design of a Dual‐Stator Low‐Speed High‐Torque Permanent Magnet Drive Machine for the Ball Mill Application

Eddy Current Loss Control in High Speed PM Starter-Generator

Design of Complex Vector Controller for High-power Induction Machine Drive

Design of Quasi-Halbach Permanent-Magnet Vernier Machine for Direct-Drive Urban Vehicle Application

Multi-Objective Design of an Interior Permanent Magnet Machine with Robustness Considerations

Design of High-Speed PMSM Considering Multi-Physics Fields and Power Converter Constraints