Abstract:Single phase rectifiers and inverters are inherently subject to double-line frequency ripple power, at both the ac and dc sides, which has adverse effects on the overall system performance. Normally a bulky capacitor is placed at the dc side of the circuit to prevent this ripple power ripple from reaching the dc source. This approach results in low power density and reliability issues. As a result, active power decoupling methods have been proposed such that the total capacitance required can be orders of magnitude smaller. This paper proposed a new power decoupling circuit, which is composed of two separate buck converters operating in each half cycle and two split dc-link capacitors. The dc link capacitors can be used to store ripple power while supporting transient power to the main output. The capacitance needed is reduced largely by allowing high voltage fluctuation on capacitors, while the dc link voltage can be controlled with small fluctuation. The dc link capacitors can be fully charged and discharged with full energy utilization. The added power decoupling module does not need dead time, and totally eliminates the shoot through concerns, which could enhance the system reliability. Another advantage of the proposed power decoupling method is that its control is independent with that of the main power stage. Modulation and control strategy are proposed for the power decoupling circuit. The operating principles together with parameters design are discussed in detail. Both simulation and experimental results prove the effectiveness of this method.

Power Decoupling Methods for Single-Phase Three-Poles Ac/Dc Converters

New Control Methods for Single Phase PWM Regenerative Rectifier with Power Decoupling Function

Study of a Single-stage Three-phase PFC DC/DC Converter With Series-parallel Connected Transforms

An Improved Power-Decoupling Scheme with Grid Inductor Phase-Shift Modification for Single-Phase Converter

Soft-Switching Single Stage Isolated Ac-Dc Converter for Single-Phase High Power Pfc Applications

Control and Modulation of a Single-Phase AC/DC Converter with Smooth Bidirectional Mode Switching and Symmetrical Decoupling Voltage Compensation

Power Decoupling Three-Port Converter with Integrated Transformer

A Multiplexing Modulation Strategy Based On Single-Phase Ac/Dc Converter With Optimized E-Capless Function

Analysis and comparison of power decoupling circuits for single-phase DC/AC converters

Carrier-Based Generalized Discontinuous PWM Strategy for Single-Phase Three-Legs Active Power Decoupling Converters

Multifunction Control Strategy for Single-Phase AC/DC Power Conversion Systems with Voltage-Sensorless Power-Decoupling Function

Efficiency improvement of a DC/AC converter with the power decoupling capability

Dual Buck Based Power Decoupling Circuit for Single Phase Inverter/rectifier

Active Power Decoupling Method for Single-Phase PWM Converters Without LC Branch Sensors

Mirror-Bridge Phase-Shift Modulation With Low Common-Mode Noise for Single-Phase CHB PFC

Minimum Switching Losses Discontinuous PWM Strategy for Bidirectional Single-Phase AC–DC Converter With Active Power Decoupling Circuit

A Novel Power Decoupling Control Method to Eliminate the Double Line Frequency Ripple of Two Stage Single-Phase DC-AC Power Conversion Systems

Three-Phase Seven-level H-bridge Commutated Active Clamped Converter

An Interleaved Three-Phase PWM Single-Stage Resonant Rectifier with High-Frequency Isolation

A Family of Single-Phase Hybrid Step-Down PFC Converters

Natural Power Factor Correction and Soft Switching Design for a Single-Stage Bidirectional Dual Active Bridge AC–DC Converter