Abstract:In an atomic vapor laser isotope separation process, the required isotope atoms are ionized selectively by a pulsed laser with a specific narrow line width, and then the produced isotope ions are extracted to the collected plates under an externally applied electromagnetic field. In the whole ion separation process, the ion extraction sub-process is one of the most important physical processes. Previous studies have shown that the key parameters of the laser-induced plasma, e.g., the initial electron number density and temperature, have a significant influence on the ion extraction features. In an actual isotope separation process, a specifically designed laser is necessary to produce the required isotope ions, which, however, leads the whole facility to have a very complicated structure, high capital cost, and especially, very narrow window of the key plasma parameters. These will, to some extent, limit a more in-depth investigation of the influences of the key plasma parameters on the ion extraction characteristics. In this paper, an ion extraction platform (ion extraction simulation experimental platform-2015, IEX-2015) is developed on the basis of a gas discharge plasma jet driven by a kilo-hertz high-voltage power supply. And an argon plasma "collisional-radiative" model is established to measure the electron temperature and number density in the plasma jet region. The experimental results show that the power input and driving frequency of the power supply and the argon mass flow rate can all affect the electron temperature and electron number density. The measured variation ranges of the electron number density and temperature are 10(9)-10(11) cm(-3) and 1.7-2.8 eV, respectively, under a chamber pressure on the order of 10(-2) Pa, which are close to the parameter levels in the actual ion extraction process. Subsequently, the preliminary ion extraction experiments are conducted under different extraction conditions including different externally applied voltages, different electrode distances and different plasma densities. The experimental results are also qualitatively consistent with those in an actual ion extraction process. The preceding preliminary experimental results show that it is feasible to conduct the ion extraction simulation study on IEX-2015. This is very helpful for systematically studying the ion extraction characteristics under different operating conditions in our future research.

Off-line Study of a Laser Ion Source Via Direct Ionization at the He-jet Outlet

Laser Ion Source Via Direct Ionization at the Outlet of A Helium Jet

A resonant ionization laser ion source at RAON

Resonant Ionization Laser Ion Source (RILIS) Development on Lu and Pr

Physical Characteristics of Ion Extraction Simulation System Based on Gas Discharge Plasma Jet

Study of Ion Extraction from Laser-Induced Air Plasma

Preliminary Design of a Hybrid Ion Source for 7li3+ Generation

The Element Selectivity And Laser Technique Of The Laser Ion Source Used For On-Line Isotope Separator

Experimental Studies on the Acceleration of Positive & Negative Ions with a Heavy Ion ISR RFQ

Commissioning of a High-Resolution Collinear Laser Spectroscopy Apparatus with a Laser Ablation Ion Source

A small high-irradiance laser ionization time-of-flight mass spectrometer.

A Hot Cavity Laser Ion Source at IGISOL

Progress in the Development of a Collinear Resonance Ionisation Laser Spectroscopy Setup

Development of A Real-Time Ion Spectrometer with A Scintillator for Laser-Driven Ion Acceleration Experiments

Development of a resonant laser ionization gas cell for high-energy, short-lived nuclei

Experimental Study on Ion Extraction Process by Electrostatic Field Between Two Parallel Plates with Adjustable Distance

Development of a 50 kV hydrogen–helium mixed ion beam implanter

Theoretical Analysis and Case Studies of One-Dimensional Ion Extraction Processes

Structure design and analysis of RF ion source for negative ion source test facility

The Laser Ion Source Trap (LIST) coupled to a gas cell catcher

Advances in Atomic Vapor Laser Isotope Separation Process——(Ⅱ): Experiment