Abstract:This article proposes an ultra-high-current 48-V-to-1-V hybrid switched-capacitor (SC) voltage regulator, named the switching bus converter, with a single-stage vertical power delivery architecture for next-generation ultra-high-power processors (e.g., graphics processing units, central processing units, application-specific integrated circuits, etc.). The proposed topology consists of two 2-to-1 SC front-ends and four 10-branch series-capacitor-buck modules, merged through four switching buses. Compared to the existing dc-bus-based architecture, the proposed switching-bus-based architecture eliminates the need for dc bus capacitors, reduces the switch count, and guarantees complete soft-charging operation. Through a topological comparison, this article reveals that the proposed topology achieves the lowest normalized switch stress and the smallest normalized passive component volume among existing 48-V-to-1-V hybrid SC demonstrations, showing great potential for both higher efficiency and higher power density than prior hybrid SC solutions. A hardware prototype was designed and built with custom four-phase coupled inductors and gate drive daughterboards to validate the functionality and performance of the proposed switching bus converter. It was tested up to 1500-A output current and achieved 92.7% peak system efficiency, 85.7% full-load system efficiency (including gate drive loss), and 759 W/in power density (by box volume), pushing the performance limit of the state-of-the-art 48-V-to-1-V solutions toward higher efficiency and higher power density.

A Novel High-Input-voltage, High Efficiency and Past Transient Voltage Regulator Module-Push-pull Forward Converter

A Five-Level Converter Interfacing Medium-Voltage

Design of High Accuracy High Conversion Ratio Single-Stage Switching Power Converter for Modern FPGAs at 10Mhz

A Comprehensive Review on Partial Power Processing-based Voltage Regulator Modules for 48-V Bus-based Data Centers

Research of a Combined Converter for Low-voltage and High-current Input

A stepless-power-reconfigurable converter for a constant current underwater observatory

A New ZVCS Resonant Voltage-Fed Push-Pull Converter for Vehicle Inverter Application

Modular High Efficiency High Density MHz DCX with Different Output Voltage Adaptation

A novel high performance voltage regulator module

Analysis and Implementation of a Single-Stage Transformer-Less Converter With High Step-Down Voltage Gain for Voltage Regulator Modules

Investigation of topology candidates for 48 V VRM

Overview of Voltage Regulator Modules in 48 V Bus-Based Data Center Power Systems

An 8A 998A/inch<SUP>3</SUP> 90.2% Peak Efficiency 48V-to-1V DC-DC Converter Adopting On-Chip Switch and GaN Hybrid Power Conversion

Study of Isolated Low-voltage High-current VRM Topologies

A Novel Fast Transient Response VRM Topology

Development of A Novel Combined Converter with Low-Voltage and High-Current Input, High Power and High-Voltage Output

A 1500-A/48-V-to-1-V Switching Bus Converter for Next-Generation Ultra-High-Power Processors

A Novel Integrated Matrix Magnetics for Isolated Single-Stage DC–DC Converter

Design and implementation of a VRM based on secondary-side controller LM5035A

High Efficiency High Power Density Cellular 1mhz 380V-12V DCX for Future Data Centers