Abstract:This brief presents a low phase noise class-C voltage-controlled oscillator with bond wire inductors. To improve the Q-factor of inductors, the voltage-controlled oscillator employs bond wires as the inductors of the resonators. A transient-analysis-compatible equivalent circuit is proposed to precisely estimate the influence of mutual inductance, parasitic components and silicon substrate. Possible phenomena of oscillation mode ambiguity and oscillation failure are analyzed to be relative with the magnetic coupling between bond wires. An equation is derived to set up the relation among oscillation mode, bond wire coupling and frequency ratio of adjacent oscillators. And a costless placement reorder method is proposed to prevent the oscillator cores from oscillating failure and mode ambiguity. The voltage-controlled oscillator is implemented in a 65-nm CMOS process. Ten groups of gold double bond wires with a 20 $\mu \text{m}$ diameter, 70 $\mu \text{m}$ height and 800 $\mu \text{m}$ horizontal length are adopted as the inductors. The total tuning range of the oscillator is from 2.22 GHz to 4.46 GHz. When oscillating at 4.46 GHz and the output frequency divide ratio is 2, the output signal provides phase noise performance of −137.3 dBc/Hz at 1 MHz offset from 2.23 GHz. The maximum power consumption is 38 mW and each oscillator core occupies a chip area of only 0.112 mm 2 .

A low-phase-noise and wide-tuning-range LC digital controlled oscillator

Linearity Enhancement Method for a Wide-Band Digitally Controlled Oscillator

A Low Noise, Low Power Fully Digitally Controlled LC Oscillator for PHS Transceivers

A 60GHz voltage-controlled oscillator with a 3.6GHz tuning range in 180nm CMOS technology

A Low Phase Noise VCO with Placement Reordered Cores and High-Q Bond Wire Array Inductors

A 0.5~0.7 V LC Digitally Controlled Oscillator Based on a Multi-Stage Capacitance Shrinking Technique

A 23-30.8 GHz Digital-Controlled-Oscillator in 28nm CMOS

A high frequency resolution digitally controlled oscillator with differential tapped inductor

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

Design of a wideband digitally controlled oscillator

A 5-8 GHz Wideband and Low Phase Noise Cross-Coupled LC VCO Using 6-bit DCCA in 40nm CMOS Process

A 6.5-Ghz Digitally-Controlled Oscillatorwith Supply Sensitivity of 0.0071%-Fdco/1%-vdd

A 3.8ghz Fully Integrated Digitally-Controlled Lc Oscillator For Phs Transceiver

A Design of DCO with 73.1% Frequency Tuning Range Based on Switched Transformer

A CMOS digital-controlled oscillator for All-digital PLL frequency synthesizer

Low Noise Fully Digitally Controlled LC Oscillator with Back-to-back in Series MOS Varactors

A Dual-Core Digitally Controlled Oscillator with a Switched Capacitor

A Noise Reduced Digitally Controlled Oscillator Using Complementary Varactor Pairs

A Noise-Insensitive High-Resolution Digitally Controlled Ring Oscillator with Multipoint-Tuning Technique

A 4.9–6.9 GHz LC VCO with low-phase-noise

An 11.7&#x2013;17.2ghz Digitally-Controlled Oscillator in 65nm CMOS for High-Band UWB Applications