Abstract:We demonstrate a novel transmission color filter design that exploits both dielectric and plasmonic resonances to establish a highly color-selective device, reaching an experimental full-width at half-maximum (fwhm) that is only half that of previously demonstrated cost-effective color filter devices for the same peak transmission and better out-of-band rejection. The measured fwhm is only 25 nm, and the peak transmission reaches up to 53%. The filter uses the interference of Fabry-Pérot resonances and guided-mode resonances in two separated dielectric slabs to achieve this excellent fwhm while relying on propagating surface plasmon polaritons to achieve the excellent out-of-band rejection. A simulation study elucidates the nature of the optical modes in the device and their interference mechanisms and reveals the most important design considerations. Fabrication was done in a CMOS pilot line and is cost-effective, as it requires only two metal patterning steps. Fabrication imperfections are discussed, together with strategies to mitigate them. We show the correct mitigation of these imperfections leads to further performance gain, enabling a full-width at half-maximum down to 20 nm and a peak transmission beyond 60%. We believe this novel filter design is a powerful concept to improve the spectral resolution of color filters for cost-effective multispectral imaging. Beyond multispectral imaging, the design could be adapted for other applications that require on-chip spectral filtering in a thin form factor.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsphotonics.1c01983.Table with dimensions of optimized unit cell designs for different pitches; Transfer matrix method applied to separate SiN sections to isolate Fabry-Pérot resonances; Simulated and measured transmission spectra for the orthogonal polarization (electric field parallel with the grating lines); Simulated transmission spectra for nonzero angle of incidence; Refractive index and extinction coefficient extracted from ellipsometry measurement (PDF)This article has not yet been cited by other publications.

Aperiodic Single-Pixel Angle-Modulated Plasmonic Color Sorter and Angle Sensor

Aperiodic Nanoplasmonic Devices for Directional Colour Filtering and Sensing

Highly Efficient Omnidirectional Structural Color Tuning Method Based on Dielectric-Metal-dielectric Structure.

Angle Robust Reflection/Transmission Plasmonic Filters Using Ultrathin Metal Patch Array

Angle-Insensitive Plasmonic Color Filters with Randomly Distributed Silver Nanodisks

Self-assembled plasmonics for angle-independent structural color displays with actively addressed black states

Nanostructured Metal-Insulator-metal Resonators for High-Resolution Color Filtering and Spectral Imaging

Plasmonic Nanoresonators for High-Resolution Colour Filtering and Spectral Imaging.

A Modular Design of Continuously Tunable Full Color Plasmonic Pixels with Broken Rotational Symmetry

Designable spectrometer-free index sensing using plasmonic Doppler gratings

Plasmonic Color Generation and Refractive Index Sensing with Three-Dimensional Air-Gap Nanocavities.

Broadband Achromatic Polarization Insensitive Metalens Design in the Near-Infrared Spectrum

Bidirectional Angle-Tolerant Polarization-Tuned Filtering and Wide-Range Refractive Index Sensing Based on Metal Film Coated Nanograting

An Integrated Optical Sensor Based on Cascaded Polarization Convertor and Slot Waveguide Microring Resonator

Angle-tolerant polarization tunable expanded reflected plasmonic color palettes

Infrared color-sorting metasurfaces

Self‐Assembled Plasmonic Coaxial Nanocavities for High‐Definition Broad‐Angle Coloring in Reflection and Transmission

Highly Selective Color Filters Based on Hybrid Plasmonic–Dielectric Nanostructures

Plasmonic Color Filter Array with High Color Purity for CMOS Image Sensors

Nanostructured Plasmonic Interferometers for Compact Sensing

Full-colour-sorting metalens based on guided mode resonance