Abstract:<p>For the estimation of frequency response function (FRF) using the window-based spectral estimation method, the error models of the FRF estimation are introduced, including window interpolation error and transient error models, and an error model-based iterative compensation (EMIC) method is then proposed to improve the FRF estimation accuracy. The specific iteration steps of the proposed EMIC method are presented, fast computations are adopted in the steps as far as possible; and that, iteration convergence and noise uncertainty are analyzed. The analyses reveal that, the proposed EMIC method is almost always convergent as long as the error of the FRF pre-estimation is small, intercepting enough data and using a window which has smaller and fewer side DFT bins as well as smaller front-end value for FRF estimation can result in better iteration convergence; whereas, the proposed EMIC method will slightly increase the noise uncertainty of FRF estimation compared with that without iterative compensation because it removes the window interpolation effects on noise just like removing the error. To verify the effectiveness and practicability of the proposed EMIC method, model simulation and actual sensor data verification are implemented, and multi existing methods are employed for comparison. The results show that, the proposed EMIC method can largely decrease the error of the FRF estimated by the window-based spectral estimation method, it has the best maximum error restraining capabilities especially in the resonance frequency band and relatively better comprehensive error restraining capabilities especially when the data is not long enough compared with the mentioned existing methods, also, the time consumption of the proposed EMIC method is acceptable and is usually seconds or less; and that, the theoretical analyses, model simulation results and actual data verification results are consistent with each other. Consequently, the proposed EMIC method is proven to be effective and practical for improving the FRF estimation of a stable LTI system from its step or impulse response data.</p>

A frequency-specific enhanced approach to transfer function approximation

Min-Max Approximation of Transfer Functions with Application to Filter Design

Estimation of Transfer-Functions - Asymptotic Theory and A Bound of Model Uncertainty

Approximate Floating-Point FFT Design with Wide Precision-Range and High Energy Efficiency.

A Hybrid Variable-Fidelity Global Approximation Modelling Method Combining Tuned Radial Basis Function Base and Kriging Correction

Low-Order Approximation Method for Frequency-Dependent Transmission Line Model

A Fuzzy Approximation for FCS-MPC in Power Converters

Passivity-preserving Model Reduction with Finite Frequency H ∞ Approximation Performance

Frequency-dependent equivalent modelling of broadband air-coupled transducers

A Closed-Form IIR Approximation of Fractional Operator Around a Prescribed Low Frequency

Model reduction for two-dimensional systems with generalized H ∞ approximation performance

Error model-based iterative compensation method for improving the estimation of frequency response function

Rational Function Approximation Using a Local Compensation Approach

Generalized H_∞ Model Reduction for Stable Two-Dimensional Discrete Systems

Frequency-limited H$_2$ Model Order Reduction Based on Relative Error

Frequency-Limited ${\mmb H}_{\infty}$ Model Reduction for Positive Systems

Effective Improvement of Under-Modeling Frequency-Domain Kalman Filter

Diffusion Map-based Algorithm for Gain Function Approximation in the Feedback Particle Filter

Fast Frequency Estimation Algorithm Using High Order Approximations to Kernel Function and Interpolation on Fourier Coefficients

Model Approximation for Discrete-Time State-Delay Systems in the T–S Fuzzy Framework

Error approximation and bias correction in dynamic problems using a recurrent neural network/finite element hybrid model