Abstract:Nondestructive testing (NDT) methods are widely used in the rail industry to detect and characterize rolling contact fatigue (RCF) defects in railroads, which is very important for railway inspection and maintenance to prevent catastrophic accidents. Existing NDT methods, e.g., ultrasonic testing (UT), magnetic flux leakage (MFL), and eddy current testing (ECT) have been successfully applied in the rail industry, and the state-of-the-art UT method reported recently achieved a high speed of 40 mi/h with a probability of detection (POD) over 80% under 30% false alarms. However, NDT methods still suffer from a bottleneck in that a higher inspection speed causes lower detection sensitivity due to their physical limits, such as negative velocity effect and long sensing time. One of the leading challenges to the rail NDT community is to develop a high-speed high-sensitivity (HSHS) capability that can provide an improved POD of rail defects in high-speed inspection scenarios over 60 mi/h. This article proposes a horizontal U-shaped magnets-based motion-induced eddy current array (MIECA) method to detect rail surface defects with the HSHS capability. The MIECA method deploys a three-axis magnetic sensor array along the rail transverse direction at the middle of the magnets to measure the MIECA signals, which utilizes the wake effect of the diffused motion-induced eddy current (MIEC) caused by the relative high-speed motion between the magnets and the rail track. Finite-element method (FEM) simulations with a wide speed range from 0 to 62.5 mi/h are carried out to investigate the relationships between the MIEC generation, diffusion and magnitude, and the three-axis MIECA signals. The simulation results show that the higher the speed, the greater the magnitude of diffused MIEC, and the greater the peak-to-peak values of three-axis MIECA signals caused by rail surface defects, which shows a great promise for detecting rail surface defects-in high-speed scenarios and is superior inspection relative to existing NDT methods in terms of inspection speed, detection sensitivity, and defect characterization capability.

Rolling Contact Fatigue Detection Using Eddy Current Pulsed Thermography

Characterization of Rolling Contact Fatigue Cracks in Rails by Eddy Current Pulsed Thermography

Research on Eddy Current Pulsed Thermography for Rolling Contact Fatigue Crack Detection and Quantification in Wheel Tread

The Early Stage Wheel Fatigue Crack Detection Using Eddy Current Pulsed Thermography

Analysis of the RCF crack detection phenomenon based on induction thermography

Nondestructive analysis of rolling contact fatigue cracks using induced scanning thermography

Dynamic Electromagnetic Thermography System for Rail Inspection

Ultrasonic Dynamic Plane Wave Imaging for High-Speed Railway Inspection

Depth quantification of rolling contact fatigue crack using skewness of eddy current pulsed thermography in stationary and scanning modes

RCF crack direction assessment in moving ferromagnetic material by DC electromagnetic NDT technique

Eddy Current Sensor Array for Electromagnetic Sensing and Crack Reconstruction with High Lift-Off in Railway Tracks

Application of eddy current testing in the quantitative evaluation of the rail cracks

Multiphysics Structured Eddy Current and Thermography Defects Diagnostics System in Moving Mode.

Detection of Closed Cracks on the Rail Surface in Thermography NDT

Study on non-destructive testing of rail rolling contact fatigue crack based on magnetic barkhausen noise

Rail crack detection and evaluation at high speed based on differential ECT system

Experimental Study of Static and Dynamic Loading Effects on Guided Wave-Based Intelligent Monitoring of Welded Rail Joints

Finite-Element Study of Motion-Induced Eddy Current Array Method for High-Speed Rail Defects Detection

Development of a Portable Pulsed Eddy Current Inspection Instrument for Rail Fatigue Crack Detection

Evaluation of typical rail defects by induction thermography: experimental results and procedure for data analysis during high-speed laboratory testing

Differential ECT Probe Design and Investigation for Detection of Rolling Contact Fatigue Cracks With Different Orientations