Abstract:Electrical characterization of semiconducting oxide nanowires (NWs) is mostly performed using complex techniques, which necessitates a series of costly nanofabrication procedures. In this work, with the aim to provide a low-cost, feasible, facile, and reproducible approach for enabling the study of NW electrical properties, we report direct electrical measurements on individual and overlapped suspended zinc oxide NWs (ZnO NWs). We have succeeded in constructing both two- and three-terminal devices simply by employing tungsten (W) nanoprobes with the aid of a nanomanipulation system embedded inside a scanning electron microscope’s vacuum chamber. Stable contacts were established using the Joule heating effect and e-beam exposure at the junctions between the NW and the pre-cleaned W tips. P-channel field-effect transistor devices were achieved with an on–off current ratio of ∼101, a threshold voltage (>1.5 V), a transconductance of ∼16 μS, a sub-threshold swing of ∼220 mV/decade, and field-effect carrier mobility roughly estimated to be around 926.4 cm2/(V·s) after correction for contact resistances/optimization. The average resistivity of ZnO NWs was calculated to be ∼2.23 × 10–2 Ω·cm for NWs with diameters between 70 and 500 nm. Besides, we have demonstrated a contact resistance of ∼19.60 kΩ and a Schottky barrier height of ∼0.37 eV present at W/ZnO NW interfaces. The contact resistance between two overlapped ZnO NWs was estimated to be ∼283 kΩ, which is relatively higher than that offered between W/ZnO NWs. This work provides a solid experimental procedure to address true intrinsic electrical properties at metal/semiconductor interfaces, and our findings have potential applications in next-generation 3D suspended ZnO NW-based nanoelectronic devices.

Continuous corona discharge using nanowires

ZnO Nanowire-Based Corona Discharge Devices Operated under Hundreds of Volts

A Mems Based Discharger Using Nanowires

Nanoscale discharge electrode for minimizing ozone emission from indoor corona devices.

AC/DC Electric-Field-Assisted Growth of ZnO Nanowires for Gas Discharge

Pulsed-laser Treatment for Lowering Resistance and Enhancing Field Emission of Solution-Grown ZnO Nanowires

Vertically Oriented Graphene Sheets Grown on Metallic Wires for Greener Corona Discharges: Lower Power Consumption and Minimized Ozone Emission

Stable, Self-Ballasting Field Emission from Zinc Oxide Nanowires Grown on an Array of Vertically Aligned Carbon Nanofibers

Influence of Copper Nanowires Grown in a Dielectric Layer on the Performance of Dielectric Barrier Discharge

Field Emission Properties of Zinc Oxide Nanowires Fabricated by Thermal Evaporation

ZnO Nanowire and $\hbox{ws}_{2}$ Nanotube Electronics

Self-sustaining discharges in needle-to-plane geometry with hundreds of microns electrode gaps

Recent Progress on ZnO Nanowires Cold Cathode and Its Applications.

Field Emission from Zinc Oxide Nanostructures and Its Degradation

Achieving Low Voltage Plasma Discharge in Aqueous Solution Using Lithographically Defined Electrodes and Metal/Dielectric Nanoparticles

Fabrication of ZnO Nanowires by Vapor-Phase Deposition and Their Field Emission Properties

Field Emission from Zno Nanostructures Prepared by Electrodeposition

Field Emission From a MOSFET-Controlled ZnO-Nanowire Cold Cathode

Field Emission Characteristics of ZnO Nanowire Driven by Pulsed Voltage

Tuning the Electrical Properties of Zno-Si Nano-Contacts and Its Effect on Field Electron Emission from Zno Nanowires

Characterization of Electrical Properties of Suspended ZnO Nanowires Using a Nanorobotic Manipulation System Inside a Scanning Electron Microscope for Nanoelectronic Applications