Abstract:To reduce negative sequence current penetration into power system caused by single-phase electrified locomotives, phase sequence commutating method among traction feeders has been adopted by electrified railways in China, which results in a neutral section without power supply between two feeders in traction substation. Loss and recovery of power supply to locomotives when passing neutral section will cause over voltage and over current in locomotives, which greatly threatens the safety of railway and passengers. A novel railway uninterruptible flexible connector is proposed in this paper, which can eliminate power supply dead zone when locomotive passing neutral section. It has the series-connected structure of back-to-back converter and transformers. Back-to-back converter is used to transfer active power needed by locomotives from one traction feeder to neutral section and transformers are adopted to reduce the capacity of converters and the complexity of control system. Instantaneous power theory is used to detect sag of neutral section voltage to start compensation and current increase to end compensation. Double close-loop control strategy is used for back-to-back converter and control system parameters are designed in accordance with typical second-order system design methodology. PSCAD/EMTDC simulations are carried out to prove the effectiveness of proposed uninterruptible flexible connector and its control system.

A New Half-Bridge Winding Compensation-Based Power Conditioning System for Electric Railway with LQRI

Capacity configuration of V/V transformer-based railway power conditioner and optimal energy compensation strategy

Analysis, design and control of a hybrid railway power conditioner considering power rating reduction

Simulation Research on a Novel Rectifier and Its Control Strategies with Functions of Reactive Power Compensation and Harmonic Current Filtering

A New Railway Power Flow Control System Coupled with Asymmetric Double Lc Branches

An Electric Railway Power Conditioning System Based on Asymmetrical Connection Balance Transformer

A New Integrated Hybrid Power Quality Control System for Electrical Railway

An Asymmetrical Connection Balance Transformer-Based Hybrid Railway Power Conditioning System with Cost-Function Optimization

Half Bridge Sub-module Based Modular Multilevel Converter in 50hz/50hz Railway Continuous Co-phase Power Supply Application

Control Scheme of Decoupled State Feedback Linearization of Single-Phase H-Bridge Cascaded STATCOM

A Novel Control Strategy for Optimization of Power Capacity Based on Railway Power Static Conditioner

An optimal control strategy for power capacity based on railway power static conditioner

Analysis and Comparison of Modular Railway Power Conditioner for High-Speed Railway Traction System

Multi-Port and -Functional Power Conditioner and Its Control Strategy with Renewable Energy Access for a Railway Traction System

Research on A Scheme of Cophase Power Supply System for Electrified Railways Based on Cascade Structure UPQC

A Compensation System for Cophase High-Speed Electric Railways by Reactive Power Generation of SHC&SAC

A Novel Power Electronic Autotransformer-Based Bipolar MVDC Electrified Railway System

An Energy Storage-Based Railway Power Flow Controller With Partial Compensation Strategy

Research on Novel Railway Uninterruptible Flexible Connector with Series-Connected Transformers and Back-to-back Converter

Modulation and Control of a New Alternate Arm Multilevel Converter for High-Voltage Direct Current System with Direct Current Fault Ride-Through Capability

A Railway Unified Power Quality Controller Based on Modular Structure for Electric Railway