Abstract:Recently, studies on particle behavior under Newtonian and non-Newtonian fluids in microchannel have attracted considerable attention because particles and cells of interest can be manipulated and separated from biological samples without any external force. In this paper, two kinds of microchannels with non-rectangular cross-section were fabricated using basic MEMS processes (photolithography, reactive ion etching and anisotropy wet etching), plasma bonding and self-alignment between two PDMS structures. They were used to achieve the experiments for inertial and elasto-inertial particle focusing under Newtonian and non-Newtonian fluids. The particle behavior was compared and investigated for different flow rates and particle size in the microchannel with rhombic and equilateral hexagonal cross section. We also investigated the influence of Newtonian fluid and viscoelastic fluid on particle migration in both microchannels through the numerical simulation. The experimental results showed the multi-line particle focusing in Newtonian fluid over a wide range of flow rates, but the single-line particle focusing was formed in the centerline under non-Newtonian fluid. The tighter particle focusing appeared under non-Newtonian fluid in the microchannel with equilateral hexagonal cross-section than in the microchannel with rhombic cross section because of the effect of an obtuse angle. It revealed that particles suspended in the channel are likely to drift toward a channel center due to a negative net elasto-inertial force throughout the cross-sectional area. Simulation results support the present experimental observation that the viscoelastic fluid in the microchannel with rhombic and equilateral hexagonal cross-section significantly influences on the particle migration toward the channel center owing to coupled effect of inertia and elasticity.

Simulation Design for Continuous Separating and 3D Focusing of Particles Based on Inertial Microfluidics

Inertial Particle Focusing and Spacing Control in Microfluidic Devices

Study on Microfluidic Inertia Focusing of Rigid Microspheres

Low-cost Multi-Core Inertial Microfluidic Centrifuge for High-Throughput Cell Concentration

Design of a Single-Layer Microchannel for Continuous Sheathless Single-Stream Particle Inertial Focusing.

Efficient Microfluidic Particle Separation Using Inertial Pre-Focusing and Pre-Separation Structures Without Sheath Flow

Numerical simulation of inertial microfluidics: a review

Inertial co-focusing of heterogeneous particles in hybrid microfluidic channels with constantly variable cross-sections

Sheathless inertial focusing chip combining a spiral channel with periodic expansion structures for efficient and stable particle sorting.

Simplified 3D hydrodynamic flow focusing for lab-on-chip single particle study

Continuous Inertial Microparticle And Blood Cell Separation In Straight Channels With Local Microstructures (Vol 16, Pg 532, 2016)

Automated design of a 3D passive microfluidic particle sorter

Design and simulation of passive mixing in microfluidic systems with geometric variations

Multiphase Ferrofluid Flows for Micro-Particle Focusing and Separation

Assessment of Lagrangian Modeling of Particle Motion in a Spiral Microchannel for Inertial Microfluidics

Three-dimensional magnetic focusing of particles and cells in ferrofluid flow through a straight microchannel

A Complete Design Flow of Dielectrophoretic Chip

Particle Focusing in a Straight Microchannel with Non-Rectangular Cross-Section

Inertial Migration of Aerosol Particles in Confined Microfluidic Channels

Vortex-aided inertial microfluidic device for continuous particle separation with high size-selectivity, efficiency, and purity.

Inertial focusing in microfluidics