Abstract:The heat transfer and flow of nanofluids in microchannel heat sink is usually numerically investigated by the single-phase model. The thermal conductivity and viscosity of nanofluids are calculated in the whole computational region because the single-phase model, assumes the nanofluids is static and nanoparticles concentration is uniform. However for the actual forced flow process, the concentration distribution of the nanofluids is not uniform. So the thermal properties of the nanofluids vary within different computational regions. With the increase of the velocity of the nanofluids, the deviation between the prediction of single-phase model and experimental results increases. In this paper, a new simulation method is proposed to consider the inhomogeneous and dynamic thermophysical properties of the nanofluids by obtaining the nonuniformly distributed nanoparticle concentration in each numerical cell. At the same time, it takes into account the following factors: the interactions between the nanoparticles, the solid wall and the base fluid, the axial conduction, the slip boundary conditions and fluid-solid coupling. The results show that the proposed numerical simulation method further improve the simulation accuracy for the forced flow and heat transfer process of nanofluids in the microchannel in a wider range. The effects of the nanoparticles concentration, Reynolds number and axial heat transfer on the thermophysical properties of the nanofluilds, the flow and heat transfer characteristics of a rectangular microchannels with hydraulic dimensions of 341μm were analyzed using the proposed simulation model. The main results are as follows: the nanoparticles are enriched at the near wall for the fully developed region; the nonuniformity of the nanofluilds thermal conductivity coefficient distribution at the channel cross section increases with the increase of the mass flow rate and the inlet centration; under the same Reynolds number, the higher the nanofluids concentration the better the heat transfer characteristics, but there is no linear relationship between the enhancement amplitude and concentration; the heat transfer coefficient of nanofluid with 1% and 2% alumina nanoparticles concentration is about 5.86% and 8.49% higher than that of deionized water, respectively; the axial conduction effect cannot be ignored for the microchannel, which significantly affects the inlet and outlet region of the microchannel especially when the Reynolds number is low. The nanofluilds temperature in the microchannel increases with the curve and does not match the conventional linear growth hypothesis.

Heat and Mass Transfer of Two-Layer Flows of Third-Grade Nano-Fluids in a Vertical Channel

Analysis of Error and Stability of Nanofluid over Horizontal Channel with Heat/Mass Transfer and Nonlinear Thermal Conductivity

Nonlinear Heat Transfer in A Two-Layer Flow with Nanofluids by Oham

Unsteady mixed nano-bioconvection flow in a horizontal channel with its upper plate expanding or contracting

Two-layer Nanofluid Flow and Heat Transfer in a Horizontal Microchannel with Electric Double Layer Effects and Magnetic Field

Numerical analysis of forced convection heat transfer in a rectangular micro-channel totally filled with Ag/ water nano fluid in slip flow regime using the lattice Boltzmann method

Peristaltic Flow and Heat Transfer of Nanofluids in a Sinusoidal Wall Channel: Two-Phase Analytical Study

Heat and mass transfer analysis of conducting non-Newtonian nanofluid flows over an elongating sheet with a non-uniform heat source

Heat and mass transfer of ternary nanofluid in permeable vertical channel sandwiched between nanofluid zones with Soret and Dufour effects using sensitivity analysis

Numerical investigation of the flow characteristics involving dissipation and slip effects in a convectively nanofluid within a porous medium

Analysis of Three-Dimensional Boundary-Layer Nanofluid Flow and Heat Transfer over a Stretching Surface by Means of the Homotopy Analysis Method

Impacts of two-phase nanofluid approach toward forced convection heat transfer within a 3D wavy horizontal channel

Numerical Investigation of Laminar Convective Heat Transfer and Pressure Drop of Water-Based Al 2 O 3 Nanofluids in a Microchannel

FLOW AND HEAT TRANSFER BEHAVIORS OF WATER-BASED NANOFLUIDS CONFINED IN NANOCHANNEL BY MOLECULAR DYNAMICS SIMULATION

Numerical heat transfer analysis of bio convective flow of non-Newtonian nanofluid with Darcy-Forchheimer effect over a curved stretching surface

Engineering applications development through OHAM in heat and mass transfer during stagnant flow of second-grade nanomaterial

Numerical investigation of heat and mass transfer in three-dimensional MHD nanoliquid flow with inclined magnetization

Numerical investigation of the effects of variable fluid properties on cilia-driven flow of tangent hyperbolic fluid in a channel with heat and mass transfer: A new approach to microfluidic pumps

Peristaltic Carreau-Yasuda nanofluid flow and mixed heat transfer analysis in an asymmetric vertical and tapered wavy wall channel

Flow and Heat Transfer in a Nano-Liquid Film over an Unsteady Stretching Surface

Two-phase simulation of entropy optimized mixed convection flow of two different shear-thinning nanomaterials in thermal and mass diffusion systems with Lorentz forces