Abstract:The heat transfer and flow of nanofluids in microchannel heat sink is usually numerically investigated by the single-phase model. The thermal conductivity and viscosity of nanofluids are calculated in the whole computational region because the single-phase model, assumes the nanofluids is static and nanoparticles concentration is uniform. However for the actual forced flow process, the concentration distribution of the nanofluids is not uniform. So the thermal properties of the nanofluids vary within different computational regions. With the increase of the velocity of the nanofluids, the deviation between the prediction of single-phase model and experimental results increases. In this paper, a new simulation method is proposed to consider the inhomogeneous and dynamic thermophysical properties of the nanofluids by obtaining the nonuniformly distributed nanoparticle concentration in each numerical cell. At the same time, it takes into account the following factors: the interactions between the nanoparticles, the solid wall and the base fluid, the axial conduction, the slip boundary conditions and fluid-solid coupling. The results show that the proposed numerical simulation method further improve the simulation accuracy for the forced flow and heat transfer process of nanofluids in the microchannel in a wider range. The effects of the nanoparticles concentration, Reynolds number and axial heat transfer on the thermophysical properties of the nanofluilds, the flow and heat transfer characteristics of a rectangular microchannels with hydraulic dimensions of 341μm were analyzed using the proposed simulation model. The main results are as follows: the nanoparticles are enriched at the near wall for the fully developed region; the nonuniformity of the nanofluilds thermal conductivity coefficient distribution at the channel cross section increases with the increase of the mass flow rate and the inlet centration; under the same Reynolds number, the higher the nanofluids concentration the better the heat transfer characteristics, but there is no linear relationship between the enhancement amplitude and concentration; the heat transfer coefficient of nanofluid with 1% and 2% alumina nanoparticles concentration is about 5.86% and 8.49% higher than that of deionized water, respectively; the axial conduction effect cannot be ignored for the microchannel, which significantly affects the inlet and outlet region of the microchannel especially when the Reynolds number is low. The nanofluilds temperature in the microchannel increases with the curve and does not match the conventional linear growth hypothesis.

Peristaltic Carreau-Yasuda nanofluid flow and mixed heat transfer analysis in an asymmetric vertical and tapered wavy wall channel

Peristaltic Flow and Heat Transfer of Nanofluids in a Sinusoidal Wall Channel: Two-Phase Analytical Study

Numerical simulation for peristalsis of Carreau-Yasuda nanofluid in curved channel with mixed convection and porous space

Peristaltic Motion of A Non-Newtonian Nanofluid in an Asymmetric Channel

Impacts of two-phase nanofluid approach toward forced convection heat transfer within a 3D wavy horizontal channel

Analysis of Error and Stability of Nanofluid over Horizontal Channel with Heat/Mass Transfer and Nonlinear Thermal Conductivity

Viscous Dissipation and Mixed Convection Effects on the Induced Magnetic Field for Peristaltic Flow of a Jeffrey Nanofluid

Pulsatile nanofluid flow with variable pressure gradient and heat transfer in wavy channel

Investigation for mixed convection flow of physiological fluid due to non-uniform vertical complex channel with entropy generation effects

Numerical Investigation of Laminar Convective Heat Transfer and Pressure Drop of Water-Based Al 2 O 3 Nanofluids in a Microchannel

Flow and heat transfer of nanofluids in a cylindrical permeable wavy channel embedded in porous medium using Buongiorno's model

Impact of two-phase hybrid nanofluid approach on mixed convection inside wavy lid-driven cavity having localized solid block

An Insight Into the Dynamics of Carreau-Yasuda Nanofluid Through a Wavy Channel with Electroosmotic Effects: Relevance to Physiological Ducts

Numerical Investigation of Forced Convective Heat Transfer and Performance Evaluation Criterion of Al2O3/Water Nanofluid Flow inside an Axisymmetric Microchannel

Thermal analysis of peristaltic flow of nanosized particles within a curved channel with second-order partial slip and porous medium

Peristaltic flow of Williamson nanofluid on a rough surface

Numerical simulation for peristaltic transport of radiative and dissipative MHD Prandtl nanofluid through the vertical asymmetric channel in the presence of double diffusion convection

Numerical Analysis of Nanofluid Flow Conveying Nanoparticles Through Expanding and Contracting Gaps Between Permeable Walls

Numerical study on nanofluidic transport mechanism in Ellis flow within curved channel comprising compliant walls subjected to peristaltic activity

Numerical investigation of nanofluid particle migration and convective heat transfer in microchannels using an Eulerian–Lagrangian approach

Heat Transfer Analysis of Carreau-Yasuda Nanofluid Flow with Variable Thermal Conductivity and Quadratic Convection