Abstract:Soldering stacks of high temperature superconducting (HTS) tapes results in a current carrying matrix with high electrical, thermal, and mechanical stability. In some applications, these tape stacks may be exposed to elevated temperatures during thermal heat cycles. Previous research on thermal degradation of high temperature superconductors has been performed with isolated crystals or individual HTS tapes, showing that oxygen-out diffusion from the rare-earth barium copper oxide (REBCO) results in a reduction of the superconducting performance. In this work, the performance of Pb37Sn63 soldered HTS tape stacks with thermal cycling to 170C is quantified through determination of the critical current Ic, the n-value, the linear resistance R in the pre-transition region of the tape stack current-voltage (I-V) traces, and the diffusion coefficient D associated with oxygen-out diffusion. The effect of tape manufacturer and nickel electroplating were considered; three soldered stacks each of unplated Faraday, nickel electroplated Faraday, unplated SuperPower, and nickel electroplated SuperPower tapes were fabricated. Across 20 - 30 one hour thermal cycles, there is no strong correlation observed between the unplated or nickel electroplated tapes. There is however a marked difference in degradation profiles observed between the SuperPower and Faraday tape stacks. For the unplated and plated SuperPower tape stacks, the degradation in Ic generally follows the model to describe oxygen-out diffusion from the superconducting REBCO layer. Significantly less degradation is observed in the unplated and plated Faraday tape stacks, and in some sections Ic even increases slightly across cycles. Further, cases of increasing Ic accompanied with decreasing n are observed, a decoupling between the two parameters. Across all samples, the linear resistance was highest in current-redistribution regions near the leads. Consistent with the model of oxygen-out diffusion and the formation of an increasingly wide oxygen deficient layer in the REBCO, the linear resistance increased with cycle number.

Influence of Oxygenation in Copper Stabilized Multifilamentary 2G HTS Tapes Made by Selective Electroplating and Laser Ablation

Performance degradation due to thermal cycling in soldered Faraday and SuperPower HTS tape stacks

Enhancement mechanism of uniaxial tensile electro-mechanical behaviors in second-generation high-temperature superconducting tapes

Thermal degradation analysis and optimization of controlled heat treatment for stacked high temperature superconducting tapes

Interfilament Resistance at 77 K in Striated HTS Coated Conductors

Optimization of REBCO Tapes through Division and Striation for Use in Superconducting Cables with Low AC Losses

Optimization of heating profile for superconductor joint performance made by resistive joule heating process

AC Loss Reduction in Multifilamentary Coated Conductors with Transposed Filaments

AC Losses of Copper Stabilized Multifilament YBCO Coated Conductors

Lamination process of second generation high temperature superconducting tape at Shanghai Superconductor Technology

Enhancement of Electro-Mechanical Behaviors in RE–Ba–Cu–O Composite Superconducting Tapes with Laser Slit Edges

Progress in fabrication of second generation high temperature superconducting tape at Shanghai Superconductor Technology

Study on the Influence of Skin Effect on AC Loss of YBCO Tape

Current-carrying properties of REBCO multi-filamentary tapes prepared by reel-to-reel ultraviolet picosecond laser cutting

Numerical Investigation of Critical Current and Magnetization Loss Effect for Twisted Stacked Tape Cable Considering Field-Angle Dependency and Mechanical Torsion Degradation

Determination of I-V Curves of HTS Tapes From The Frequency Dependent AC Transport Loss

AC losses in HTS sector shaped high-current conductors for fusion coils

Conductive Buffer Layers and Overlayers for the Thermal Stability of Coated Conductors

Influence of HTS tape arrangement on the transverse compression performance of copper former CORC cables

High-Temperature Superconducting Cable Design Based on Individual Insulated Conductors

STUDY ON THE PERFORMANCES OF SEVERAL LAMINATED Bi-2223/Ag HIGH TEMPERATURE SUPERCONDUCTOR TAPE COMPOSITE STRUCTURES