Abstract:The aim of the project was to develop a HMI (Human-Machine Interface) with the help of which a person could remotely control and monitor the Vacuum measurement system. The Vacuum measurement system was constructed using a DAQ (Data Acquisition & Control) implementation instead of a PLC based implementation because of the cost involvement and complexity involved in deployment when only one basic parameter i.e. vacuum is required to be measured. The system is to be installed in the Superconducting Cyclotron section of VECC. The need for remote monitoring arises as during the operation of the K500 Superconducting Cyclotron, people are not allowed to enter within a certain specified range due to effective ion radiation. Using the designed software i.e. HMI the following objective of remote monitoring could be achieved effortlessly from any area which is in the safe zone. Moreover the software was designed in a way that data could be recorded real time and in an unmanned way. The hardware is also easy to setup and overcomes the complexity involved in interfacing a PLC with other hardware. The deployment time is also quite fast. Lastly, the practical results obtained showed an appreciable degree of accuracy of the system and friendliness with the user.

A Remote High Precision Data Acquisition System through Internet Transmission

Real-time Data Transmission of the Digital Simulation System Based on Network

WIDE AREA MEASUREMENT AND REAL-TIME TRANSMISSION SYSTEM FOR PHASOR DATA UNDER NETWORK COMMUNICATION MODE

ON-LINE IDENTIFICATION OF POWER SYSTEM DYNAMIC EQUIVALENT Part Four On-Line Identification Installation

Multi-node data acquisition and analysis system for the development of AT electronic control unit.

Design and FPGA Verification of a Novel Reliable Real-Time Data Transfer System

Design of the Remote Monitoring and Fault Diagnosis System for Power Electronic Equipment

The Design of MDF Remote Intelligent Supervisor System with S3C44B0X

Control of Wireless Network Communication for Industrial Robot Servo Systems

A Multi-Sensor Acquisition and Control System

Research of a New High-Performance Data-Collecting Transmissive System

Data Acquisition and Distributed Computing System Based on Embedded Network

Realization of a Visual Remote Network Control and Measurement System Based on Virtual Instruments

A Data Acquisition System in Intelligent Environmental Monitoring Device for Industrial Field

Data acquisition system based on LabVIEW for array sensors

Design and Implementation of Sensor Data Recording System

Internet-based automation equipment intelligent monitor system

Remote Monitor & Measurement Instrument System Faced To Internet Interoperable Service Of Manufacturing

Design of Remote Monitoring System Based on STM32F407 Microcontroller

On-Line Monitoring System of HVCB Based on FPGA and ARM

Study and Development of a Data Acquisition & Control (DAQ) System using TCP/Modbus Protocol