2.5 A 2-to-6ghz Class-AB Power Amplifier with 28.4% PAE in 65nm CMOS Supporting 256QAM

Wanxin Ye,Kaixue Ma,Kiat Seng Yeo

DOI: https://doi.org/10.1109/isscc.2015.7062914

2015-01-01

Abstract:Wideband power amplifiers (PAs) with high power-added efficiency (PAE) are required by software-defined radio and high-data-rate communications. A PA in Class-AB, which can provide linear amplification with PAE better than Class-A, has been reported in [1] to achieve bandwidth larger than one octave. However, Class-AB operation generates a large amount of 2nd-harmonic current at the transistor output, which has amplitude as high as up to 42% of the fundamental current in theory [2]. An output matching network, providing optimum load impedance only at the fundamental frequency, is insufficient to achieve good power performance, bringing big challenges to integrated Class-AB PA design with octave bandwidth. In this work, we demonstrate a 2-to-6GHz (fractional bandwidth of 115.5%) Class-AB PA designed in 65nm CMOS. An output matching technique based on differential architecture, which enables the PA to achieve a maximum PAE of 28.4% and an overall PAE above 19%, is proposed to provide transistor output with optimum load impedance for both fundamental and 2nd harmonic over an octave bandwidth. Without using any pre-distortion, the PA can deliver output power of 9.31 to 11.31dBm with EVM<;-32dB for 256QAM signal (802.11ac format, 20MHz bandwidth) from 2 to 6GHz.