Finite Element Research on Cutting Force and Temperature in Milling 300M Steel.

Sen Lin,Fangyu Peng,Yizhi Liu,Sheng Yang,Rong Yan

DOI: https://doi.org/10.1007/978-3-642-40849-6_49

2013-01-01

Abstract:Cutting force and temperature are major concerns in the aircraft landing gear manufacture to implement milling for 300M steel. These two factors strongly influence the surface characteristics of a machined product that have close relation with functional performance of the product. This paper describes investigations realised to perform simulations of end milling operations on 300M steel via AdvantEdge FEM software. In the simulations, the geometry of cutting tool is measured by coordinate measuring machine and modeled in UG software. The material flow stress data are obtained from Split Hopkinson Bar experiment. The material behaviour is modelled with a classical Johnson—Cook law to accomplish the thermo-mechanical analysis. Good agreements between the numerical results and experimental data at various cutting velocities prove that the proposed model is capable of predicting the cutting forces and temperatures during milling of 300M steel accurately.