Abstract:We propose a downstream/upstream (DS/US) WDM-SDM-PON architecture employing the multicore fiber (MCF) realizing 300Gb/s aggregation DS rate and 20Gb/s US rate per wavelength. Figure 1 depicts the experimental setup. For DS transmission, ten wavelengths with 25GHz channel spacing are selected by a waveshaper from an optical frequency comb generator (OFCG)which is driven by a ECL seed laser centered at 1550.116nm. Then the ten CWs are simutaneously intensity modulated with 5Gb/s baseband QPSK-OFDM signal generated off-line by Matlab, where the IFFT/FFT size is 128 and 63 effective subcarriers are used to convey data information. The length of cyclic prefix (CP) of OFDM signal is 13, which is long enough to conquer the impact of chromatic dispersion of MCF. Boosted by EDFA, the signals are power splitted and simutaneously injected into one of six outer cores of the MCF through the fan-in device. After 60km MCF transmission, the signals are output through fan-out device. The fan-in/fan-out device is fabricated using chemical etched optical fiber bundles method [1]. After pre-amplifier and optical bandpass filter, one wavelength of output signal is directly detected by a photodetector (PD) with 4GHz bandwidth and then sampled by a 20GS/s digital sampled oscilloscope (DSO). Demodulation and bit error ratio (BER) counting are implemented offline. The DS transmission results are illustrated in Figure 2(a). No significant transmission performance deterioration is observed between OB2B and MCF transmission for all six spatial channels, and the BER can be kept under 3.8x10-3 at the received optical power of -16dBm. For US transmission, a CW laser from ECL is modulated by an IQ modulator with 20Gb/s QPSK signal generated by BER tester (BERT). The signal reusing the same wavelength is transmitted in the inner core of MCF to avoid the interference of Rayleigh backscattering effect. After amplification and filtering, the signal with power of about -1dBm is coherently detected at the optical line terminal. The US transmission result is shown in figure 2(b), which shows that more than 18 dB power budget can be guaranteed.

Triplexer Chips for FTTH

Novel Triplexer Chip Design Combination of an Asymmetric Y Branch Waveguide and A Multimode Interference

Monolithically Integrated Fiber-to-the-home Diplexers and Triplexers Using a Bilevel Etched 2×2 Optical Coupler

A Compact Triplexer Based on InP/InGaAsP-MMI Coupler with Channel-Shaped Core Layer for 50G PON

Monolithically integrated FTTH diplexer using bi-level etched 2×2 optical coupler

Low-loss and Low-Crosstalk Silicon Triplexer Based on Cascaded Multimode Waveguide Gratings.

Experimental demonstration of cross-order arrayed waveguide grating triplexer

A Novel Triplexer Design Based on Arrayed Waveguide Grating

An On-Chip Silicon Compact Triplexer Based on Cascaded Tilted Multimode Interference Couplers

Experimental Demonstration of a Broadband Two-Mode Multi/demultiplexer Based on Asymmetric Y-junctions

An Ultracompact Silicon Triplexer Based on Cascaded Bent Directional Couplers

Novel Wavelength Multiplexer Using (<italic>N</italic> + 1) × (<italic>N</italic> + 1) Arrayed Waveguide Grating and Polarization-Combiner-Rotator on SOI Platform

Silicon Three-Mode (de)multiplexer Based on Cascaded Asymmetric Y Junctions.

Ultra-Compact Birefringence-Compensated Arrayed Waveguide Grating Triplexer Based on Silicon-On-Insulator

A segment-coupled six-mode multiplexer based on multi-core fiber

Silicon Multi-band On-chip Mode-division (de)multiplexing for High-speed Optical Interconnect in Both EDFA and TDFA Wavebands

Ultra-broadband multimode fiber-to-chip edge coupler based on periodically segmented waveguides

Fiber-Chip Bi-Wavelength Multiplexing with Subwavelength Single-Etch Grating Coupler and Diplexer

Ultra-short silicon MMI duplexer

A Duplex Ultra-Dense WDM/SDM-PON with Multicore Fiber and Advanced Modulation Formats

Novel Ultracompact Triplexer Based on Photonic Crystal Waveguides