Abstract:To obtain low surface roughness in the laser-assisted machining of 3Y-TZP ceramics, a laser-assisted heating model of 3Y-TZP ceramics was established. The temperature field in the cutting zone was simulated using ABAQUS software to analyze the effects of laser power, rotational speed, and warm-up time on softening layer depth (distance between the workpiece surface and lower boundary of softening layer) and thickness (distance between the upper and lower boundaries of softening layer). Furthermore, the accuracy of the simulation results was verified through experiments. The Plackett-Burman design, Steepest ascent experiment, and Box-Behnken design method were used sequentially to optimize process parameters, and the surface quality, chip morphology, and tool wear of 3Y-TZP ceramic with laser-assisted cutting and traditional cutting were compared under the best process parameters. The results show that the rotational speed and laser power are the main factors influencing the softening layer depth and thickness, and the suitable warm-up time is 15 s; the most influential factor on the surface roughness is the cutting depth, and the optimized process parameter combinations for the best surface roughness are as follows: laser power of 90.3 W, rotational speed of 400 r/min, cutting depth of 0.21 mm, and feed speed of 4.4 mm/min; with laser-assisted, the surface roughness value of the workpiece is reduced by 54.12 %, the amount of tool wear is reduced by 56.5 %, the chip morphology is transformed from powder to strip with a length of more than 50 μm, and the primary material removal mode is changed from brittle removal to plastic removal.

Effect of Technological Parameters on Laser-Controlled Thermal Stress Cutting Quality of Ceramics

Numerical analysis of laser-controlled thermal stress cutting of an alumina ceramic

Simulation and analysis of laser-controlled thermal stress cutting of alumina ceramic

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Microwave thermal stress method cutting Al2O3 ceramics: modeling and experiments

Laser machining technology with the effect of thermal soften and thermal stress

Three-dimensional Thermal Analysis for Laser Assisted Machining of Ceramics Using FEA

Understanding the Processing Quality Problem for Cutting Ceramic Materials Using the Thermal-Controlled Fracture Method Induced by a Single-Surface Heat Source

Simulation and Experimental Study on Group Hole Laser Ablation on AL2O3 Ceramics

Stress Relief Mechanism in Layer-Wise Laser Directly Sintered Porcelain Ceramics

Generalized thermoelasticity study in ultrashort pulsed laser machining of ceramic considering material removal and variable material properties

Numerical Simulation of the Al2O3/ZrO2 (Y2O3) Ceramic Cutting Tool During Cutting Process's Temperature Fields and Stress Fields

Theoretical and experimental investigations in thermo-mechanical properties of fused silica with pulsed CO2 laser ablation

Scan Pattern, Stress and Mechanical Strength of Laser Directly Sintered Ceramics

Distribution of Temperature Fields for Laser Heating Assisted Cutting of Ceramics

Tailored microwave thermal crack heating model and its application in cutting ceramics

Numerical Simulation and Experimental Analysis of Thermal Conduction and Stress in Laser Cladding Repair of Thin-Walled Parts

Effect of process parameters on crack characteristics in laser welding of Al2O3 ceramic

Numerical Simulation and Experimental Investigation of Laser Ablation of Al2O3 Ceramic Coating

Temperature field simulation and optimization of processing parameters for laser-assisted machining of 3Y-TZP ceramics

Numerical simulation of the preheating effect on temperature gradient in laser cladding Al2O3 ceramic