Abstract:This paper compares several approaches to model the unsteady and nonlinear longitudinal aerodynamics of a generic unmanned combat air vehicle configuration based on computational fluid dynamics (CFD). Three different reduced-order models (ROMs) are implemented through unsteady simulations to predict the evolution of forces and moments during prescribed trajectories carried out at [Formula: see text]. The first model investigates a linear quasi-steady model based on a first-order Taylor series expansion of the aerodynamic coefficients. The second one picks up the mathematical formulation of the first model but adds a dynamic coefficient in order to take into account the unsteady effect of rotation rate variations. Finally, the third model is built on indicial functions computed from positive step changes in the angle of attack or pitch rate. The unknown parameters of the first two models and the unknown indicial functions of the third one are obtained, respectively, from the study of forced oscillations and step motions. These prescribed trajectories are performed using unsteady Reynolds-averaged Navier–Stokes simulations coupled with a grid displacement tool. Two different methods are tested and compared to carry out the CFD mesh motions: an overset method and a full moving grid (FMG) method. The indicial functions obtained using the FMG method give results equivalent to those found in the literature in half the time of the overset method. To reduce the computational costs to set up the ROMs, the FMG method is preferred to the overset method. ROMs are then applied, and their predictions are compared with CFD simulations for prescribed trajectories with different angular rates and angles of attack. A study of instantaneous and overall accuracy associated with the implementation cost of the ROMs has allowed to show their strengths and their weaknesses. Similar results are observed at low angles of attack for the ROMs studied, while a major modeling advantage of the indicial method has been identified for higher angles of attack in the nonlinear domain.

AN EFFICIENT METHOD ON AERODYNAMIC DAMPING COEFFICIENT CALCULATION FOR TuRBOMACHINERY

A novel unsteady aerodynamic Reduced-Order Modeling method for transonic aeroelastic optimization

An Efficient Implementation of Transonic Aeroelastic Tailoring based on a Reduced-Order Model using Structural Dynamic Reanalysis Method

Coupled Fluid-structure Aeroelastic Analysis of Turbomachinery Using Conservative Data Transfer Algorithm

A Combined Method of CFD Simulation and Modified Beddoes-Leishman Model to Predict the Dynamic Stall Characterizations of S809 Airfoil

An Efficient Coupled-Mode Flutter Analysis Method for Turbomachinery

Calculation of Damping Ratio and Analysis of Damping Effect of Turbine Blade Dry Friction Damper in Rotating State

Evaluation of reduced-order models for the rapid aerodynamic analysis of supersonic and hypersonic bodies

A Fast Aeroelastic Response Prediction Method Based on Proper Orthogonal Decomposition Reduced Order Model

Highly Efficient Atmospheric Turbulence Response Analysis of Composite Aircraft Wings Using Pseudo-Excitation Method

A reduced-order model for compressible flows with buffeting condition using higher order dynamic mode decomposition with a mode selection criterion

Accuracy and Computational Cost Comparison of Numerical Flight Dynamics Reduced-Order Models

Numerical calculation on wind-induced damping of membrane structure based on fluid-structure interaction

An Efficient Method for Transient Response of Rotor Systems Based on Squeeze Film Damper

Reduced Order Models for the Aerodynamic Calculation of the Wind Turbine Airfoil

Preliminary Numerical Validation of the Frequency Response Method on the Study of Aero-Damping in a Linear Oscillating Compressor Cascade

Efficient Aeroelastic Reduced Order Model with Global Structural Modifications

A viscous blade body force model for computational fluid dynamics–based throughflow analysis of axial compressors

Study on A New Aerodynamic Model of Hawt Based on Panel Method and Reduced Order Model Using Proper Orthogonal Decomposition

An efficient implementation of aeroelastic tailoring based on efficient computational fluid dynamics-based reduced order model

Study on the aerodynamic damping for the seismic analysis of wind turbines in operation