Abstract:In this dissertation, the relationships between structure-mechanical properties-deformation mechanisms in face-centered cubic (FCC) and body-centered cubic (BCC) metallic nanowires have been studied using in situ TEM nanomechanical testing. It is well known that smaller is stronger and the widely-observed size effect is believed to arise from dislocation interactions inside nanocrystals. However, the interaction mechanisms in small-volume nanocrystals remain unexplored. Here, it was found that surface-nucleated dislocations can strongly interact inside the confined volume of Au nanowires, which led to a new type of dislocation-originated stacking fault tetrahedra (SFT), at variance to the widely-believed vacancy-originated SFT. The atomic-scale processes of nucleation, migration and annihilation of dislocation-originated SFT were revealed, shedding new light onto the strain hardening and size effect in small-volume materials. Although nanoscale twinning is an effective mean to enhance the strength of metals, twin-size effect on the deformation and failure of nanotwinned metals remains largely unexplored, especially at the minimum twin size. Here, a new type of size effect in nanotwinned Au nanowires is presented. As twin size reaches the angstrom-scale, Au nanowires exhibit a remarkable ductile-to-brittle transition that is governed by the heterogeneous-to-homogeneous dislocation nucleation transition. Quantitative measurements show that approaching such a nanotwin size limit gives rise to the ultra-high strength in Au nanowires, close to the ideal strength limit of perfect Au. Twinning is a fundamental deformation mode that competes against dislocation slip in crystals. At the nanoscale, higher stresses are required for plastic deformation than that in bulk, which favors twinning over dislocation slip. Indeed, deformation twinning has been well-documented in FCC nanocrystals. However, it remains unexplored in BCC nanostructures. Here, it shows that twinning is the dominant deformation mode in BCC-tungsten nanocrystals. A competition between twinning and dislocation slip occurs when changing the loading orientations, attributed to the defect growth controlled plasticity in BCC nanocrystals. Several important commonalities and differences in FCC and BCC nanocrystals deforming at nanoscale are further proposed. The results from this dissertation advance fundamental understanding of plastic deformation in a broad class of metals and alloys, and are of technological importance for degradation control and future design of ultra-strength nanomaterials.

Defect-Dominated Diameter Dependence of Fracture Strength in Single-Crystalline Zno Nanowires: in Situ Experiments

Quantifying the Defect-Dominated Size Effect of Fracture Strain in Single Crystalline Zno Nanowires

Exploration of the Defect’s Effect on the Mechanical Properties of Different Orientated Nanowires

Atomistic Exploration of Deformation Properties of Copper Nanowires with Pre-Existing Defects

Exceptional Deformability of Wurtzite Zinc Oxide Nanowires with Growth Axial Stacking Faults

Molecular Dynamics Study Of Dynamic Buckling Properties Of Nanowires With Defects

Bending Properties of Ag Nanowires with Pre-Existing Surface Defects

Advanced Numerical Characterization of Mono-Crystalline Copper with Defects

Atomistic Numerical Investigation of Single-crystal Copper Nanowire with Surface Defects

Numerical Exploration of Plastic Deformation Mechanisms of Copper Nanowires with Surface Defects

Numerical Exploration Of The Defect'S Effect On Mechanical Properties Of Nanowires Under Torsion

In Situ TEM Study on the Nanomechanical Behaviors of Metallic Nanowires

Surface Stress Effects On The Yield Strength In Nanotwinned Polycrystal Face-Centered-Cubic Metallic Nanowires

Tensile Properties of Si Nanowires with Faulted Stacking Layers

Bending Strength and Flexibility of Zno Nanowires

Influence of atomic defect on the deformation properties of nanowires subjected to uniaxial tension

Diameter Dependence of Modulus in Zinc Oxide Nanowires and the Effect of Loading Mode: in Situ Experiments and Universal Core-Shell Approach

Effect of Size on Fracture and Tensile Manipulation of Gold Nanowires

Failure mode transformation of ZnO nanowires under uniaxial compression: from phase transition to buckling.

An Atomistic Study of the Deformation Behavior of Tungsten Nanowires

Effect of Surface Morphology on the Mechanical Properties of ZnO Nanowires