Abstract:AA2060-T8 is a relatively new Al-Cu-Li alloy developed in the last few years as a lightweight alternative to conventional Al alloys. Thus, it is essential to characterize the warm flow, fracture, and anisotropic behaviours of this alloy and propose constitutive analysis-based crystal plasticity (CP) modelling to link its mechanical behaviour with the microstructural state. Therefore, in this study, isothermal warm tensile tests were conducted using a Gleeble-3800 thermomechanical simulator and different sample orientations at temperatures and strain rates varying from 373 to 573 K and 0.001 to 0.1 s −1 , respectively. The tensile behaviour of the 2060 Al-Cu-Li alloy sheet depends on the sample orientations, which results in significant anisotropy. The anisotropic degree of the tensile properties of this alloy was significantly reduced by increasing the forming temperature above 473 K. In addition, the fracture behaviours of 2060 Al-Cu-Li sheets were transformed from mixed ductile-brittle fracture mode to ductile fracture mode by decreasing strain rates and increasing the temperatures, respectively. Afterward, a novel crystal plasticity model was proposed to describe the grain behaviour and the deformation mechanism of 2060 Al-Cu-Li alloy under warm forming conditions. The developed constitutive model was implemented using the monolithic time-integration algorithm-based backward Euler method. The results acquired from the proposed constitutive analysis agree well with those obtained from experimentation in all testing conditions. This indicates its ability to accurately predict the warm flow behaviour of 2060 Al-Cu-Li alloy under different strain rates and loading directions.

The Characteristics of Plastic Flow and a Physically-Based Model for 3003 Al–Mn Alloy Upon a Wide Range of Strain Rates and Temperatures

Plastic Flow Characteristics and Physical Conception Constitutive Relation for AZ31 Cast Magnesium Alloy

Plastic flow characteristics and constitutive relation of ultra high strength steel 18Ni250

Strain Rate Sensitivity and Constitutive Models of Several Typical Aluminum Alloys

Plastic Flow Characteristics and Physically‐based Constitutive Modelling of Commercially Pure Vanadium

Plastic Behavior and Constitutive Relations of DH-36 Steel over a Wide Spectrum of Strain Rates and Temperatures under Tension

Dynamic plasticity of AZ31 magnesium alloy: Experimental investigation and constitutive modeling

Investigation on Plastic Flow Behaviors of FCC Polycrystalline Aluminum under Pre-Cyclic Tension-Compression Loading: Experiments and Crystal Plasticity Modeling.

Flow Stress and Constitutive Model of OFHC Cu for Large Deformation, Different Temperatures and Different Strain Rates

PLASTIC FLOW STRESSES AND CONSTITUTIVE MODELS OF FOUR NEWER NAVAL VESSEL STEELS

Flow Stress Behavior and Constitutive Model of 7055 Aluminum Alloy During Hot Plastic Deformation

Experimental and Physical-Based Constitutive Model Study of Fcc Metal over Wide Temperature and Strain Rate Ranges

Modeling the Hot Deformation Behavior of Al Alloy 3003

Characterization of Hot Deformation Behavior and Constitutive Modeling of Al–Mg–Si–Mn–Cr Alloy

The flow behavior of homogenizated Al-Mg-Si-La aluminum alloy during hot deformation

SUPERPLASTIC BEHAVIOR OF COARSE-GRAINED Al-Mg ALLOY

A Physically-Based Constitutive Modelling of a High Strength Aluminum Alloy at Hot Working Conditions

Double-humped Temperature Dependence of Plastic Behaviour of K403 Superalloy and Its Constitutive Model

Characterization and constitutive analysis-based crystal plasticity of warm flow and fracture behaviours of 2060 Al-Cu-Li alloy

Investigation of Superplasticity in Aluminum Alloy 5083

Hot Deformation Constitutive Model and Processing Maps of Homogenized Al–5Mg–3Zn–1Cu Alloy