Abstract:In this study, an exhaust system compliant with future regulations was developed for a non-road 110PS engine with a Tier-4f aftertreatment system, and the emission characteristics of the engine were investigated in the non-road transient mode (NRTC). For the system to comply with future exhaust regulations, a DPF was installed, and an electrical heated catalyst (EHC) device was installed to manage exhaust gas temperature. The emission characteristics of exhaust gas were examined according to the power and applied duration of EHC, and the effects of catalyst coating and the urea water solution (UWS) injection map on NOx reduction, NH3 slip, and N2O emissions in NRTC mode were investigated. The application of a 4 kW class EHC system enables the lowering of the injection starting temperature of the UWS, as reliable gas heating (heating duration control) is guaranteed. When the injection starting temperature (based on the SCR inlet temperature) was set to 150 °C, NSR map, (III) in conjunction with the operation of the EHC, effectively achieved significant NOx reduction in NRTC mode without deposit and wetting occurring in the mixer and exhaust pipe. Regarding changes in EHC power from 3 kW to 4 kW, it was observed that a NOx reduction of 0.05 g/kWh occurs in the cold NRTC mode, but in the hot NRTC mode, it was found that the relative decrease in the UWS is due to the increased NO2 conversion efficiency as a result of the oxidation catalyst, making 3 kW more advantageous. Furthermore, due to the increase in NO2 concentration caused by the oxidation catalyst and the increase in the low-temperature injected UWS, NH4NO3 was formed, which resulted in an increase in PM emissions and a significant increase in N2O emissions around an exhaust temperature of 250 °C. When the EHC power was set to 3 kW and the volume of oxidation catalyst and the amount of UWS injection were adjusted, applying EHC in the NRTC mode resulted in an additional NOx reduction of 58.6% and 88.4% in cold and hot modes, respectively, compared with not using EHC, with a fuel penalty of approximately 1.67%, while limiting the peak concentrations of N2O and NH3.

Experimental study of reducing si engine emissions during cold-start and warm-up phase based on thermal management strategies with a heater

An Assessment of the Application of Catalyst Preheating Prior to Engine Cold Start to Improve the Filtration Performance of CDPF on Particulate Emissions

An Experimental Study on the Measures for Improving Cold Start/Warm-up Process of Engine

Experimental Research on Gasoline Engine Emission of Cold-Start Period for a Gasoline Engine Combined with a Heater

Experimental Study on Reducing Exhaust Emission During Cold-Start Period of Gasoline Engine Using a Heater

Reducing Cold Start Emissions from Automotive Diesel Engine at Cold Ambient Temperatures

On the emission reduction through the application of an electrically heated catalyst to a diesel vehicle

Intake Air Heating Strategy to Reduce Cold-Start Emissions from Diesel Engines

Improving Cold Start and Transient Performance of Automotive Diesel Engine at Low Ambient Temperatures

Fuel Consumption and Emission Reduction for Non-Road Diesel Engines with Electrically Heated Catalysts

Starting Control Strategy and Experimental Study of CNG Engine

Hc, Co and Nox Emissions Reduction Efficiency of A Prototype Catalyst in Gasoline Bi-Mode Si/Hcci Engine

Experimental investigation on the combustion and emissions in a pilot ignited direct injection natural gas engine using HCDI strategy

A Novel Valve Strategy for Particulate Matter Reduction in a Gasoline Direct Injection Engine Operated at Cold Conditions

Hydrocarbon adsorption mechanism of modern automobile engines and methods of reducing hydrocarbon emissions during cold start process: A review

Experimental Investigation of Cold-Start Unregulated Emissions and Combustion Characteristics of Low-Percent Methanol-Gasoline Engine

Evaluation of thermal management technologies for fuel efficient cold-start emissions reduction in diesel engines

Lean combustion and EGR with charge stratification in a spark ignition engine

Experimental Study on the Impact of Hydrogen Injection Strategy on Combustion Performance in Internal Combustion Engines

Experimental Investigation of Homogeneous Charge Induced Ignition (hcii) with Low-Pressure Injection to Reduce Pm Emissions in A Heavy-Duty Engine

A review of studies using hydrocarbon adsorption material for reducing hydrocarbon emissions from cold start of gasoline engine