Abstract:External gear pumps are among the most popular fluid power positive displacement pumps; however, they often suffer from excessive flow pulsation transmitted to the downstream circuit. To meet the increasing demand of quiet operation for modern fluid power systems, it is necessary to give a physically sound method of analyzing the operation of a volumetric pump. The analysis of the basic approach used by the majority of researchers for calculating the flow rate of a gear pump by E.M. Yudin is presented. The article presents a new method for analyzing the operation of volumetric pumps. The method is suitable for the pumps whose dynamic characteristics should be considered according to the model of an equivalent source of flow fluctuations by V.P. Shorin. The method is based on wave theory, the method of hydrodynamic analogies and the impedance method, where the pump is considered according to the model in lumped parameters. The method consists in determining the pressure pulsations at the pump output in bench systems with known dynamic characteristics and recalculating the pump flow rate in pulsations. Computational dynamic models of bench systems in lumped parameters are proposed for subsequent use in dynamic tests of pumps in the form of equivalent sources of fluid flow fluctuations. We give recommendations for the formation of test bench systems with a throttle, a cavity and a pipeline at the pump output. Using the example of an external gear pump with a working volume of 14 cm3/rev, the implementation of the proposed method is considered. The pump's own pulsation characteristic of the flow rate in a bench system with an "infinitely long" pipeline along two harmonic components of the spectrum is determined, and a test of the method based on the method of determining the instantaneous flow rate by R.N. Starobinskiy is proposed. It is shown that, according to the proposed method and the method of R.N. Starobinskiy, the divergence of the amplitudes of flow pulsations does not exceed (5–10)%. The high degree of coincidence of the results confirms that the external gear pump in question should be considered according to the equivalent source of flow fluctuations model.

Analysis of flow characteristic of multi-compound gear pump

Research of Flow Pulsation & Gear Hobbing of Third-order Non-circular Gear Pumps

Research of low flow pulsation of high-order elliptic gear pump

Investigation of Fluid Delivery and Trapped Volume Performances of Truninger Gear Pump by a Discretization Approach

Design of the conjugated straight-line internal gear pairs for fluid power gear machines

Study on Tooth Profile of Involute Conjugated Internal Gear for High-Pressure Internal Gear Pumps

Analysis of Flow Characteristics of A Cam Rotor Pump

Analysis Of The Flow Pulsation Characteristics Of The Gear Pump Used in Electro-Hydrostatic Actuator

Research on Flow Characteristics of Straight Line Conjugate Internal Meshing Gear Pump

New Method to Determine the Dynamic Fluid Flow Rate at the Gear Pump Outlet

Theoretical analysis on flow characteristics of melt gear pump

Analysis of Pressure Pulsation in Aviation Gear Pump

Analysis and Optimization on U-shaped Damping Groove for Flow Ripple Reduction of Fixed Displacement Axial-Piston Pump

Flow characteristics and factors affecting flow pulsation of external meshing herringbone gear pump

Analysis of Flow Characteristics of Straight Conjugate Crescent Gear Pump at Variable Working Conditions

Theoretical flowrate characteristics of the conjugated involute internal gear pump

Study on Multi-flow Field Characteristics of Unloading Groove Spacing of Bidirectional Gear Pump

Analysis of the Flow Dynamics Characteristics of an Axial Piston Pump Based on the Computational Fluid Dynamics Method

Development of a Numerical Approach for the CFD Simulation of a Gear Pump under Actual Operating Conditions

Pulsation Test and Analysis of Internal Gear Pump Used in Electro-hydraulic Actuator

Flow Ripple Reduction of Axial-Piston Pump by Structure Optimizing of Outlet Triangular Damping Groove