Abstract:The improvement of the overall performance of hydraulic pumps is the basis of intelligent hydraulics. Taking the straight line conjugate internal meshing gear pump as the research object, the theoretical flow rate and the geometric flow pulsation rate equations are established in this study through the volume change method. The change laws of the gear pair’s geometric parameters on the theoretical flow rate and the geometric flow pulsation rate are studied. The simulation model of the internal flow channel is established, and the influence factors and the influence degree of the flow pulsation and average flow rate are analyzed. The high-pressure positive displacement pump test system is also designed and built. The performance evaluations are conducted, and the experimental results are analyzed. The results show that the periodic change of the meshing point position is the root cause of the geometric flow pulsation. The theoretical flow rate and the geometric flow pulsation rate are 103.71 L/min and 1.76%, respectively. To increase the theoretical flow rate whilst decreasing the geometric flow pulsation rate, the tip circle radius of the external gear should be increased as much as possible within the allowable range of the design calculation. Amongst the three influencing factors that produce flow pulsation, the oil compressibility has no effect on the flow pulsation. The uneven internal leakage is the main factor, and the geometric flow pulsation only accounts for a small proportion. The internal leakage reduces the simulated flow rate by 3.59 L/min. The difference between the experimental and simulated flow rates is less than 2%. Within the allowable speed range, the rotation speed of the external gear should be increased as much as possible to increase the average flow rate and the volumetric efficiency.

Study on Tooth Profile of Involute Conjugated Internal Gear for High-Pressure Internal Gear Pumps

Design of the conjugated straight-line internal gear pairs for fluid power gear machines

Research of Flow Pulsation & Gear Hobbing of Third-order Non-circular Gear Pumps

Research of low flow pulsation of high-order elliptic gear pump

Investigation of Fluid Delivery and Trapped Volume Performances of Truninger Gear Pump by a Discretization Approach

Experimental Research on Performance of Water Hydraulic Internal Gear Pump

Theoretical flowrate characteristics of the conjugated involute internal gear pump

Calculation of Tooth Profile Curve of Cycloidal Pump Based on Conversion Method

Design and fluid analysis of the microsegment gear tooth profile for pump operating at high speed and high pressure

Mathematical design and meshing analysis of a new internal gear transmission based on spatial involute-helix curve

Geometric design and analysis of face-gear drive with involute helical pinion

Tooth Contact Analysis of Involute Gear

Gear Tooth Profile Reconstruction via Geometrically Compensated Laser Triangulation Measurements

Tooth Profile Modification of Helical Gears and Experimental Study Based on Finite Element Contact Analysis

Gearing Principle of Conical Involute Non-Circular Gear and Simulation Model

Research on Flow Characteristics of Straight Line Conjugate Internal Meshing Gear Pump

Simulation Research on Trapped Oil Pressure of Involute Internal Gear Pump

Numerical Modeling of a Helical External Gear Pump With Continuous-Contact Gear Profile: A Comparison Between a Lumped-Parameter and a 3D CFD Approach of Simulation

Mathematic model and tooth contact analysis of a new spiral non-circular bevel gear

Static/dynamic Contact FEA and Experimental Study for Tooth Profile Modification of Helical Gears

Pitch Cone Design and Avoidance of Contact Envelope and Tooth Undercutting for Conical Worm Gear Drives