Abstract:The assessment of mechanical properties of metal foil under complicated stress states poses a considerable challenge, requiring the development of new testing methods and the optimization of new specimen geometry. In this research, the biaxial tensile method and specimen shape were designed and optimized by using simulation and experiment. It is determined that the strain measurement area can be suggested as the central area of 0.6 to 0.8 times the arm width. The influence of different parameters on the tensile results of cruciform specimens was comprehensively evaluated by finite element method and multi-factor analysis. The results indicate that the number of slits markedly impacts the stress-strain uniformity and shear stress in the central region, followed by the slit length. The effect of the arm width and the slit width is comparable, more influential than the corner radius. According to the analyzed results and application requirements, a four-axis independently driven biaxial tensile test machine for small scale samples was fabricated. During the biaxial tension, the center point offset of the specimen remains within +/- 0.01 mm. The displacement and load synchronization errors do not exceed 0.01 mm and 50 N, respectively, facilitating the precise control of four-axis synchronization. Conclusively, cruciform specimens featuring diverse geometric characteristics were designed for industrial pure titanium, 304 stainless steel, and Inconel 718 superalloy with thickness of less than 0.3 mm. The biaxial tensile tests were performed to delineate the yield loci, revealing notable anisotropy and size effect. The validation confirms the suitability of the testing method and optimized cruciform specimens for conducting biaxial tensile mechanical properties testing on metal foils characterized by diverse types and thicknesses.

Optimal Design and Examination Study of Biaxial Tensile Specimens for Solid Propellant

Design of specimen for composite solid propellant biaxial tensile experiment

Biaxial Tensile Mechanical Properties of HTPB Solid Propellant

Biaxial Tensile Experiment for Composite Solid Propellant With Crack

A New Test Method to Obtain Biaxial Tensile Behaviors of Solid Propellant at High Strain Rates

Study on the Relationship Between Microscopic Structure and Mechanical Properties of HTPB Propellant

Deformation of Solid Propellant Grains under Axial Acceleration Load

A Study of Experimental Method for Mechanical Properties of Solid Propellant under Hydrostatic Compressive Loading

Study on Dynamic Compressive Mechanical Behavior of Solid Propellant

Biaxial Tensile Test and Simulation of Rear Pressure Bulkhead Reinforcement Components with Composite

Mechanical Behaviors and Failure Mechanisms of CMDB Propellant under Wide Strain Rate Tension Loading

Shape Optimization of a Composite Cruciform Specimen under Biaxial Loading Condition

Biaxial Tensile Behavior of Ti-6Al-4V under Proportional Loadings at High Strain Rates

Impact Experimental Investigation of Dynamic Tensile Characteristics of Composite Modified Double Base Propellant

Biaxial Tensile Behavior of Ti-6Al-4V under Proportional Loading

Fundamental problem in optimizing the biaxial testing specimen

Structural Integrity Analyses on the Anti-high Overload of a Solid Rocket Motor

FEM SIMULATION AND ANALYSIS OF CRUCIFORM BIAXIAL TENSILE TEST

Dewetting Stress of Solid Propellant under Tensile Loading

Design of a biaxial tensile testing device and cruciform specimens for large plastic deformation in the central zone

Investigation on the Biaxial Tensile Testing Method for Metal Foil Using Cruciform Specimen