Abstract:Silicon -based ultra -thin flat heat pipes (UFHPs) that can be integrated with semiconductor devices provide an opportunity for electronic thermal management. To meet the requirements of various operation states, the impacts of gravity on the liquid plug characteristics and heat transfer performance of an UFHP are investigated by a visualization experiment conducted at different incline angles. Condensate flows back through microgrooves under the capillary pressure and gravity under a low heating power (capillary flow stage), and then excess condensate flows back along the edges of the UFHP under a higher heating power (gravitational flow stage). Over a certain heating power ( Q >= 14 W), liquid plug fluctuations caused by vapor entrainment are observed with periodic dry -out at the evaporator under large incline angles ( alpha >= 60 degrees ), corresponding to temperature fluctuations. Intense fluctuations of the liquid plug enhance sensible heat transfer, although the liquid plug occupies the condenser area and impedes the vapor flow. Meanwhile, evaporation at the evaporator benefits from corner -film evaporation until a large area of dry -out occurs. Due to the increased gravity and buoyancy, a larger incline angle is conducive to thermal performance enhancement, but this effect becomes restricted as the heating power rises. At a cooling -water temperature of 20 degrees C and an incline angle of 90 degrees , the lowest thermal resistances of the UFHP yield a value of 1.14 degrees C/W at 4 W in the steady stage and a value of 1.22 degrees C/W at 18 W in the fluctuation stage, respectively. The heat transfer limit of UFHP with overfilling reaches 24 W, compared with the theoretical heat transfer capacity of 8.9 W at an incline angle of 90 degrees . Additionally, a higher cooling -water temperature is beneficial for the thermal performance in the capillary flow stage, but not in the gravitational flow stage and fluctuation stage. This study provides guidance for the operational design of silicon -based UFHP for electronic thermal management.

The Development of Polymer-Based Flat Heat Pipes

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Investigation on the Influence of Different Heat Transmission Distances on Thermo-Hydrodynamic Characteristics of Pulsating Heat Pipes

Review of the Development of Pulsating Heat Pipe for Heat Dissipation

Investigation on Transient Behaviors of Flat Plate Heat Pipes

A novel fabrication method for polymeric flat plate pulsating heat pipe via additive manufacturing

Fabrication and Performance Evaluation of Flexible Flat Heat Pipes for the Thermal Control of Deployable Structure

Liquid Plug Characteristics and Heat Transfer Performance of a Silicon-Based Ultra-Thin Flat Heat Pipe at Different Incline Angles

An Experimental Study of a Composite Wick Structure for Ultra-Thin Flattened Heat Pipes

Fabrication and Thermal Performance of a Polymer-Based Flexible Oscillating Heat Pipe via 3D Printing Technology

Thermal performance of flat plate heat pipe array with surface wettability modification: An experimental and simulation study

A SiC Based Integrated Micropillar Array Wick Thin Plate Heat Pipe Investigation

The Visualized Investigation of a Silicon Based Built-in Heat Pipe Micropillar Wick Structure

Study of a new thin flat loop heat pipe for electronics

Ultrathin flexible heat pipes with Microsorum fortunei structural-like wick for cooling flexible electronic devices

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

An Experimental Investigation on the Heat Transfer Characteristics of Pulsating Heat Pipe with Adaptive Structured Channels

Surface Wettability Modifications and Applications in Wickless Heat Pipes

Experimental study on a rectangular evaporator loop heat pipe with a phase-change material heat sink

Experimental investigation on a 0.5-metre-long aluminum flat heat pipe for thermal management in electronic devices