Abstract:The solidification path of alloy reveals the detailed relationship between the solute concentration in liquid and the temperature during the solidification process. The best and most accurate method to predict the solidification path of multicomponent/multiphase alloys is to establish proper microsegregation modeling coupled with phase diagram calculations according to the CALPHAD method. Recently, several alloy systems such as Al-Cu, Al-Mg and Cu-Mg have been developed, which have aroused the interest of many researchers. Up to now, the research about Al-Cu-Mg ternary alloy, especially containing higher Mg content, is relatively rare. The purpose of the present work is to investigate the solidification path of Al-6.32Cu-25.13Mg (mass fraction, %) ternary eutectic alloy at different cooling rates and solid back diffusion coefficients by an extended unified microsegregation model coupled with Thermo-Calc. Solidification experiments and subsequent microstructural characterization are combined with numerical calculation of solidification paths. It was shown that the cooling rates R-f had no obvious effect on the solidification path which was (L+alpha)->(L+alpha+T)->(L+alpha+beta+T); but the solid back diffusion coefficient 0 had a great effect on the solidification path, which evolved gradually from (L+alpha)->(L+alpha+T)->(L+alpha+beta+T) into (L+alpha)->(L+alpha+T) when Phi increased from 0 to 1. The volume fractions of primary alpha phase V-alpha, binary eutectic V-2E and ternary eutectic V-3E at each solidification path were calculated. It was shown that V2E decreased with the increase of R-f whereas V-3E increased and V-alpha was almost invariant. The dependence of V-2E, V-3E and R-f were determined by linear regression analysis given as: V-2E=-2.51gR(f)+64.9, V-3E=2.51gR(f)-F22.12. The increase in Phi led to increases in V-alpha and V-2E and decrease in V-3E. The predicted solidification paths and volume fractions of A1-6.32Cu-25.13Mg ternary eutectic alloy at different cooling rates were in good agreement with experimental results.

Solute Distribution and Segregation During Solidification of Mg-6ai Alloys

Thermal and Solute Diffusion During Dendrite Growth of Mg-5wt.%Zn Alloy

Evolution of the Microstructure and Microsegregation in Subrapidly Solidified Mg–6Al–4Zn–1.2Sn Magnesium Alloy

Experimental Characterization and First-Principles Calculations of Zn Segregation at the Β″-Mg5al2si4/al Interfaces in Al-Mg-Si Alloys

Examination of dendritic growth and microsegregation during solidification of Al–Li binary alloy using the phase-field simulation coupling CALPHAD data

Atomistic insight into impact of solute segregation on α-Mg/FCC-Al 2 Ca interface stability

Segregation and Morphological Evolution of Si Phase during Electromagnetic Directional Solidification of Hypereutectic Al-Si Alloys

In Situ Observation of Microstructure and Precipitate Phase Transformation during the Solidification of Mg‐Containing GH3625 Alloy at Different Cooling Rates

Directional Solidification and Microsegregation in a Magnesium-Aluminum-Calcium Alloy

Simulation on microstructure evolution of Al−Si alloy under effect of natural convection during solidification

Effect of Cooling Rate on Solidification Parameters and Microstructure of Al-7Si-0.3Mg-0.15Fe Alloy

Thermal and solute diffusion in α-Mg dendrite growth of Mg-5wt.%Zn alloy

Interface velocity dependent solute trapping and phase selection during rapid solidification of laser melted hypo-eutectic Al-11at.%Cu alloy

Growth and morphology evolution of icosahedral quasicrystal phase in Mg 30Zn 60Y 10 alloy

Effect of Cooling Rate on the Grain Morphology and Element Segregation Behavior of Fe-Mn-Al-C Low-Density Steel During Solidification

In situ analysis of solute and flow fields in directional solidification of immiscible Al–Bi alloy

Prediction of the Solidification Path of Al-6.32cu-25.13mg Alloy by A Unified Microsegregation Model Coupled with Thermo-Calc

A Quantitative Study of the Solute Diffusion Zone During Solidification of Al-Cu Alloys Via In-Situ Synchrotron X-radiography and Numerical Simulation

Solidification shrinkage and shrinkage-induced melt convection and their relation with solute segregation in binary alloys

Macrosegregation and channel segregation formation of faceted mushy zone in solidification of Sn–Ni hypereutectic alloy in a temperature gradient

Phase-field Simulations of Dendrite Morphologies and Selected Evolution of Primary Α-Mg Phases During the Solidification of Mg-rich Mg–Al-based Alloys