Abstract:An attempt is made in this study to research the performance of prestressed concrete pipe piles based on 10,333 pile tests. Short and medium-length piles with slenderness ratios ranging from 10 to 90 are most widely used, and the optimal length is between the range of 10~50 m. For the same bearing stratum and diameter, the capacity of pile increases with increasing pile length until a limiting value is achieved. The average pile-top settlement is approximately in the range of 10 ~ 25 mm, and the rebound rates for piles with various lengths are similar. The results show that the diameter of Φ400 and Φ500 is most widely used, accounting for 33.8% and 46.1%, respectively, and the optimal length is between the range of 10 ~ 50 m. Under conditions of, when the bearing stratum is clay, the bearing capacity of pipe piles increases with an increase in length to diameter ratio; when sandy soil, the bearing capacity firstly increases and then decreases; when with the same length to diameter ratio, the bearing capacity increases in both cases, and the latter is higher than the former. There is a large discreteness in settlement of pile top, and the average value is normally about 10 ~ 25 mm, without significant relationship with the bearing stratum. The results of statistical research will be a reliable reference for pipe pile research, design and construction in soft soil area. The results are expected to improve the understanding of prestressed concrete pipe piles and facilitate the design process.

Mechanical Property for Cast-in-situ X-shaped Concrete Pile of Reinforced Soft Roadbed

Statistical research on performance of prestressed concrete pipe piles

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

Experimental Analysis of Bearing Capacity of Cast-in-place Tubular Pile

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

In-situ Experiment on Urban Road Subgrade Improved by Plain Concrete Pile and Mixed-in-place Pile

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

STUDY ON SINGLE RIGID PILE GROUND IMPROVEMENT MODEL UNDER EMBANKMENT

Experimental Study on Bearing Capacity Behavior of Deep Large Diameter Cast-in-place Belled Pile

Study on Axial Bearing Properties of Cast-in-place Concrete Thin-Wall Tubular Piles

Model Test And Numerical Analysis Of Geogrid-Reinforced Pile-Supported Foundation

Assessment of Cohesive Soil Landslide Driving Forces Exerted on Piles Considering Soil Arching Effects

Influence of the Penetration of Adjacent X-section Cast-in-place Concrete (XCC) Pile on the Existing XCC Pile in Sand

Laboratory Model Study on the Pile-Forming Mechanisms and Bearing Deformation Characteristics of CFA Piles

Behavior of Sand Filled Nodular Piles under Compression in Soft Soil Areas

Bearing Behaviors of Self-Balanced Pile

Engineering Character of a New-Style Pretensioned Spun Concrete Nodular Pile

Field Behavior of Pre-Stressed High-Strength Concrete Nodular Piles and PHC Pipe Piles Under Compression in Soft Soil Areas

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

A Model Test on the Behavior of A Static Drill Rooted Nodular Pile under Compression