Abstract:Cross ventilation can effectively improve air quality with larger ventilation rate than single-sided natural ventilation. The measurement of ventilation rate is critical for research on indoor environmental maintenance and air quality control. This investigation compared four methods of obtaining the cross ventilation rate in a residence, including direct measurement by the tracer-gas-decay method, and indirect measurement with ultrasonic anemometers, from the wind speed at a reference position, and from the differential pressure between two sides of the residence. Furthermore, measured wind speed in the direction normal to the opening was used to analyze the unsteady and non-unidirectional flow characteristics, and the airflow consistency σ was found to be in the range of 50%–98%. The results show that when σ > 90%, the internal airflow was close to unidirectional flow, and the ventilation rates in all rooms were similar. As the ratio σ decreased, the error between the measured and calculated ventilation rate at the openings increased. When σ < 70% with severe non-unidirectional flow, the presumed ventilation volume based on the measured wind speed at one opening had a large deviation from the measured ventilation rate at the other. We then calculated the volume of air intake and outflow at the same opening. On the basis of volume conservation, the exchange ventilation rates between internal rooms were obtained by the tracer-gas-decay method combined with ultrasonic anemometers to measure the wind speed at the openings of the multi-zone dwellings. Therefore, single tracer-gas-decay method with ultrasonic anemometer at the openings can measure the cross ventilation rate and obtained the ventilation rate between internal rooms of the multi-zone residence.

Measurement of Natural Ventilation for Residential Building in Guangzhou

Temporal variation of wall flow and its influences on energy balance of the building wall

Measurement of Cross-Ventilation Rate in Urban Multi-Zone Dwellings

Measurement of Natural Ventilation Rate of Residences in Beijing, China

Study on Natural Ventilation Potential of Ordinary Office Buildings in Guangzhou Based on Architectural Factors

Numerical simulation and site measurements of ventilation efficiency for different types of air-conditioned rooms through window-opening natural ventilation

Investigation of Ventilation Behaviors in Mechanically Ventilated Residential Buildings in China

Ventilation Characteristics and Performance Evaluation of Different Window-Opening Forms in a Typical Office Room

Experimental study of building natural ventilation with pendulum velocity anemometer

Design optimization and field demonstration of natural ventilation for high-rise residential buildings

Estimation model for natural ventilation by wind force considering wind direction and building orientation for low-rise building in China

Natural ventilation potential for residential buildings in a densely built-up and highly polluted environment. A case study

A model for calculating single-sided natural ventilation rate in an urban residential apartment

Evaluating the influence of openings configuration on natural ventilation performance of residential units in Hong Kong

Research on the Impact of Air Temperature and Wind Speed on Ventilation in University Dormitories under Different Wind Directions (Northeast China)

Analysis of Natural Ventilation Performance Gap between Design Stage and Actual Operation of Office Buildings

Using natural ventilation in office buildings under subtropical climate: A case Study in Shenzhen

Ventilation Behavior in Residential Buildings with Mechanical Ventilation Systems Across Different Climate Zones in China

Natural ventilation cooling effectiveness classification for building design addressing climate characteristics

Experimental and CFD study of ventilation performance enhanced by roof window and mechanical ventilation system with different design strategies