Abstract:Base isolation has been widely investigated and used in civil infrastructures all over the world. However, it still has some problems need to be solved. For example, extra buffers are needed for some types of isolators to prevent them from generating too large deformation. These buffers increase the cost of isolators and make them more complicated. In addition, some isolators may have residual deformation and need to be repaired or replaced after large earthquake. This also induces large cost. In order to develop novel isolators with self buffer and with residual deformation self-recovery ability, two types of materials, stainless steel metallic pseudo-rubber (SS-MPR) and shape memory alloy metallic pseudo-rubber (SMA-MPR), were fabricated and investigated in this study. Mechanical behaviors of these two materials were investigated, together with deformation self-recovery ability of SMA-MPR material. Meanwhile, three types of SMA-MPR specimens with various processing procedures were fabricated. Mechanical behavior of the SS-MPR and SMA-MPR specimens under cyclic sinusoidal compression loadings with various loading frequencies were test. After that, the three types of SMA-MPR specimens with residual deformation were put into a temperature controlled stove and their deformation recovery ability were tested. In order to address if these SMA-MPR specimens still have stable mechanical properties after deformation recovery, they were installed in the test machine and their stress-strain behavior under cyclic sinusoidal loads were tested again. Experimental results indicated that both SS-MPR and SMA-MPR are good potential material to develop novel seismic isolators for civil infrastructures.

Design and study on novel shape memory alloy isotator

A New Isolation Device Using Shape Memory Alloy and Its Application for Long-Span Structures

Modelling and Experimental Study of Shape Memory Alloys Coil Spring Actuator

Modeling and Simulation of SMA Wire Actuator

A NOVEL SELF-CENTERING ENERGY DISSIPATION DEVICE WITH SHAPE MEMORY ALLOYS CONSIDERING TEMPERATURE EFFECTS

Experimental Study on Mechanical Behavior of Self-Centering Isolators Made of Shape Memory Alloy Metal Rubber

Experimental Study of Superelasticity of Ni-Ti Shape Memory Alloy Wires

Experimental Investigation and Numerical Evaluation of an Innovative Shape Memory Alloy Damper

Study on capability measurements and controls of shape memory alloy wires

Simulation and Design of SMA Muscle

Simplified multidimensional constitutive model of super-elasticity shape memory alloy

Experimental Investigation On A Novel 3-D Isolator Made Of Shape Memory Alloy Pseudo-Rubber

Experimental and Theoretical Study on Two Types of Shape Memory Alloy Devices

Multifactor Experimental Investigation of the Mechanical Performance of a Shape Memory Alloy‐based Self‐centering‐energy‐dissipation Device

Optimal design of novel spatial bending SMA actuator based on heat analysis

Tensile Test of Shape Memory Alloys and Numerical Simulation

Experimental study on mechanical properties of large NiTi superelastic shape memory alloy bars

Topology optimization for energy dissipation structures based on shape memory alloys

New Materials for Isolators in Civil Infrastructures: Stainless Steel-Metallic Pseudo Rubber and SMA-metallic Pseudo Rubber

Comparative Study of Two Types of Self-Recovery Shape-Memory Alloy Pseudo-Rubber Isolator Devices under Compression–shear Interactions

Study Of A New Application Form Of Shape Memory Alloy Superelasticity