CO 2 , Ar, and He dilution effects on combustion dynamics and characteristics in a laboratory-scale combustor
Osman Kumuk
DOI: https://doi.org/10.1016/j.fuel.2024.131745
IF: 7.4
2024-05-02
Fuel
Abstract:This study aimed to investigate the impact of CO 2 , Ar, and He addition on combustion instability under varying acoustic frequencies, dynamic pressure amplitudes, and light emission intensities. Experiments involved using pure methane as fuel at a 1.0 equivalence ratio, with three distinct acoustic frequencies. The burner operated at 5 kW, and the combustion chamber was excited at frequencies of 90 Hz, 160 Hz, and 320 Hz. It was observed that with dilution, the temperatures decreased more from the burner exit temperature to the exhaust section. As the oxygen concentration in the oxidizer decreases in Ar, He, and CO 2 dilution, CO emissions increase, but CO 2 emissions decrease. The addition of Ar, He, and CO 2 causes an effect that reduces the flame temperature and brightness while causing the flame length to extend due to the diluting effect. While a decrease in instability was observed in He-Ar-CO 2 dilution in 20 % oxygen, instability increased again in the three 19 % cases. It is observed that mixtures under the diluent effect approach the blowoff limit due to the increase in ignition delay. It has been determined that the addition of diluent increases the tendency for the flame to go out, especially due to the thermal effect. The methane fuel with an 18 % oxygen concentration in the oxidizer of Ar remained below lean extinction limits, undergoing blowoff. The temperature was measured as 1156 K at 21 % oxygen concentration, 584 K at 19 % oxygen concentration for carbon dioxide, 877 K for Helium, and finally 777 K for argon. In the case of pure air for the combustion of methane, CO emissions were measured at 140 ppm. Average CO levels at 20 % oxygen concentration in the oxidizer are 1254 ppm, 356 ppm, and 308 ppm with carbon dioxide, argon, and helium, respectively. The study also shows that an increase in O 2 in oxidizing air leads to a decrease in CO emissions, while an increase in He/Ar/CO 2 gases leads to an increase in CO emissions. Regarding NO X emissions, undiluted conditions measured a value of 14 ppm. NO X emission levels approached 0 ppm in all dilution cases and achieved its goal.
energy & fuels,engineering, chemical