Abstract:The effect of convection and diffusion introduced by sample size and curvatures on microstructures, stability of solid/liquid (S/L) interface, and solute distribution in an Al-4.5wtpctCu alloy was studied with growth velocity between 1 and 96 μ m/s. The experiments were undertaken via directional solidification within coaxial tubes of a variety of diameters. The intent was to achieve the same temperature gradient and growth velocity but different magnitudes of convection. The results indicate that with respect to planar growth, the growth front of the smallest diameter samples (1 mm) in the inner tube is less stable than that of large diameter (7.3 mm). The samples with the smallest diameter have weak convection and show no planar growth. Because of the reduced convection, the transition from cellular-to-dendritic growth occurs at relatively slow growth rate (4 μ m/s). Increasing sample sizes results in formation of a planar growth front. The interface position of the inner smaller samples is located behind that of the outer larger samples, and more interfacial Cu segregation is found in smaller samples than in larger samples because of convection reductions in small samples. The change of the curvature of the samples affects the convection. At certain conditions, small curvature results in reduced convection. Samples with smaller sizes and therefore reduced convections have larger S/L curvatures than the larger samples.

Effect of Dimensionless Parameters on CdZnTe Crystal Growth in Detached Solidification

Progress in Convection Effects on Dendritic Growth Using Phase-field Method

Thermal and Solute Diffusion During Dendrite Growth of Mg-5wt.%Zn Alloy

Effect of crystal rotation on the instability of thermocapillary–buoyancy convection in a Czochralski model

Studies on Thermal and Interface Optimization for CdZnTe Crystals by Unseeded Traveling Heater Method

Melt Convection and Temperature Distribution in 300 Mm Czochralski Crystal Growth with Transverse Magnetic Field

Three-dimensional thermosolutal simulation of dendritic and eutectic growth

Numerical Study of ACRT in the THM Growth of CdZnTe Crystals

Effect of Cooling Rate on Te Inclusions in CdZnTe Crystal

Numerical analysis of Cd1−xZnxTe crystal growth by the vertical Bridgman method using the accelerated crucible rotation technique

Effect of a Traveling Magnetic Field on Cadmium Zinc Telluride Growth by the Traveling Heater Method

Effects of cusp-shaped magnetic field on melt convection and oxygen transport in an industrial CZ-Si crystal growth

The Concentration Distribution and X-Ray Measurement of Nearby the Cd1 -xZnxTe Solid-liquid Interface

New Way to Suppress the Instability of Thermal Convection

Thermosolutal Convection and Solute Segregation of Hg1−xCdxTe Alloy During the Vertical Bridgman Single Crystal Growth

Effect of Liquid Encapsulation on Thermocapillary Convection in Molten Liquid under Microgravity Condition

Numerical Simulation of Effect of Thermal Gradient on Structure Evolution During Directional Solidification of Ti-Al Alloy

Magnetic Field-Enhanced Thermoelectric Performance in Dirac Semimetal Cd3As2 Crystals with Different Carrier Concentrations

Effect of Marangoni Convection on Microstructure Evolution of Cu-Pb Hypermonotectic Alloy by Phase Field Simulation

Numerical simulation of cellular/dendrite transition and its growth during directional solidification of Ti44Al alloy

The Effect of Convection on Microstructures and Interface Stability of Al-4.5wtpctCu Alloy Made by Directional Solidification