Abstract:In the quest for ultra-high-efficiency silicon solar cells, optimising surface passivation has emerged as a critical pathway to minimise losses and enhance device performance. Recent breakthroughs in aluminium oxide (AlO x ) passivation show an interface to Si with low interface defect density and high negative charge density after activation annealing at 400–450 °C, enabling low surface recombination velocities. The formation of an interfacial SiO x layer has been recognised as a key factor. In this study, we present an in-depth investigation of a SiO x /AlO x /SiN x nanolayer stack interface with Si, where the SiO x is wet chemically grown. By varying the AlO x deposition from 5 to 40 ALD cycles, we observed a reduction in interface defect density, indicating the presence of negatively charged hydrogen in the AlO x layer. We reveal a distinctly different interface between Si and nanolayer stacks with or without AlO x . Activation annealing significantly reduced recombination losses for stacks with AlO x , attributed to increased charge density and decreased carrier capture velocity at the valence band-tail. We find lower electron capture rates in nanolayer stacks containing AlO x , suggesting effective passivation of donor states by negatively charged hydrogen. Additionally, the formation of new acceptor states was detected by an increase in hole capture velocity at the interface after annealing. Electron energy loss spectroscopy (EELS) identified an Al:SiO x N y layer of ∼2.5 nm thick with excess oxygen content and a mixture of tetrahedral and octahedral coordinated Al, likely contributing to the formation of acceptor defects and suggest an intrinsic link between the chemical and field-effect passivation.

Enhancing Photovoltaic Characteristics of Iron Doped Amphous Carbon/Al2o3/Si Solar Cell by Al2o3 Interface Passivation

Photovoltaic And Photoconductivity Characteristics Of (A-C:Fe)/Al2o3/Si Structure

Photovoltaic and photoconductivity characteristics of (a‐C:Fe)/Al <sub>2</sub> O <sub>3</sub> /Si structure

Properties of Fe Doped Amorphous Carbon Thin Films for Photovoltaic Solar Cell Applications

Photovoltaic Effect of A-C: Fe/AlOx/Si Based Heterostructures

Enhancing Photovoltaic Effect of Co-2-C-98/Al2o3/Si Heterostructures by Al2o3

Simulation of a Charged Al2O3 Film as an Assisting Passivation Layer for a-Si Passivated Contact P-Type Silicon Solar Cells

Improved Amorphous/crystalline Silicon Interface Passivation for Silicon Heterojunction Solar Cells by Hot-Wire Atomic Hydrogen During Doped A-Si:H Deposition

Effective Hydrogenation Strategies to Boost Efficiency over 20% for Crystalline Silicon Solar Cell with Al2O3/Cu2O Passivating Contact

Improved passivation effect at the amorphous/crystalline silicon interface due to ultrathin SiOx layers pre-formed in chemical solutions

Enhanced Si Passivation and PERC Solar Cell Efficiency by Atomic Layer Deposited Aluminum Oxide with Two-step Post Annealing

Effective Interface Pretreatment For Amorphous-Crystalline Silicon Heterojunction Solar Cells

Enhancing Ag-alloyed Cu 2 ZnSnS 4 solar cell performance by interfacial modification via In and Al

The Application of Al2tio5 at the Tio2/Perovskite Interface to Decrease Carrier Losses in Solar Cells

Importance of Nanocrystallites in A-Si:H Passivation Layer in Improving the Performance of Silicon Heterojunction Solar Cells

Interfacial Engineering of Cu 2 O Passivating Contact for Efficient Crystalline Silicon Solar Cells with an Al 2 O 3 Passivation Layer

Pinhole-like Carriers Transport in Spin-Coating SiO2 Enabling High-Efficiency Dopant-Free Si Solar Cells

Enhanced Device Performance of Si Nanowires/si Nanocrystals Heterojunction Solar Cells with Ultrathin Al2O3 Passivation

Light-soaking Enhanced Passivation of Al2O3 on Crystalline Silicon Surface

Effects of CuAlO2 on the heterojunction interface and performance of Cu2ZnSn(S,Se)4 thin-film solar cells

Oxide-nitride nanolayer stacks for enhanced passivation of p-type surfaces in silicon solar cells