Abstract:Electron beam selective melting (EBSM), is powder bed fusion additive manufacturing (AM) technique by adding materials layer upon layer. The capacity of EBSM to fabricate complex and multi-functional parts has made it a realm of great interest for researchers in the domain of science. However, during the fabrication of functionally graded materials (FGMs) with graded composition by EBSM using at least two different materials, it is difficult to separate and reuse these materials after the fabrication. Additionally, it is difficult to vary the powder composition within a layer to fabricate a horizontal graded structure. In this research, an element evaporation concept based on electron beam powder bed fusion, is presented for fabricating one-dimensional (1D) FGMs of (α2 + γ) TiAl alloy/(α + β) titanium alloy from a single material powder. By irradiating different sub-regions of the powder bed with electron beam energy input of different magnitude to greatly reduce the relative atomic ratio of aluminum from 47% to less than 10%, the 1D FGMs structures with (α2 + α + β) phases in the interfacial transition zone (ITZ) were successfully produced. Since the microstructure of the ITZ has a significant effect on mechanical properties for the 1D FGMs, three different overlap scan distances (0.5, 1.0 and 2.0 mm), which result in different ITZs, were utilized for evaluating the microstructure of the ITZ and resulting mechanical properties. The results showed that no defects were found in the specimens of any overlap distance. Moreover, the width of the ITZ increases as the overlap scan distance, and the tensile strength decreases with the overlap scan distance.

Preparation of a Functionally Gradient Aluminum Alloy Metal Matrix Composite Using the Technique of Spray Deposition

Study on the preparation of the SiCp/Al–20Si–3Cu functionally graded material using spray deposition

Synthesis of Functionally Graded AA7075-B4C Composite with Multi-Level Gradient Structure

Preparation of 6066 Al/SiCP(+ Gr) composites by multi-layer spray deposition

Preparation of 7075/6009 Gradient Materials by Semi-continuous Casting Technique

Preparation of 7075/6009 Gradient Aluminum Matrix Composites by Semi-continuous Casting

Fabrication of functionally graded materials from a single material by selective evaporation in electron beam powder bed fusion

A Novel Preparation Approach of Aluminum-Based Functionally Graded Material: Auxiliary Wire Filling Gas Metal Arc Directed Energy Deposition

Fabrication process of smooth functionally graded materials through a real-time inline control of the component ratio

A functionally graded material design from stainless steel to Ni-based superalloy by laser metal deposition coupled with thermodynamic prediction

Review on the Research of Preparation Processes on Functionally Gradient Materials

Dual-gradient ceramic/aluminum composite structure fabricated by arc additive manufacturing with co-conveying of wire and powder

Solid-state Additive Manufacturing High Performance Aluminum Alloy 6061 Enabled by an In-Situ Micro-Forging Assisted Cold Spray

Rapid Fabrication of Functionally Gradient Material Parts by Laser Beam

Fabrication and characterization of stainless steel 308 L / Inconel 625 functionally graded material with continuous change in composition by dual-wire arc additive manufacturing

The Study of Preparation Process of Spray Formed 7075/al–si Bimetallic Gradient Composite Plate

Research Progress in Aluminum Silicon Gradient Materials for Electronic Packaging Prepared by Spray Forming

Fabrication of in situ Al/Mg2Si functionally graded materials by electromagnetic separation method

Additive Manufacturing of Horizontal and 3D Functionally Graded 316L/Cu10Sn Components via Multiple Material Selective Laser Melting

Functionally graded materials with grain-size gradients and heterogeneous microstructures achieved by additive manufacturing

Characterization of Interfacial Transition Zone of Functionally Graded Materials with Graded Composition from a Single Material in Electron Beam Powder Bed Fusion