A Study on the Influence of Hole’s Diameter with Holed Casing Treatment

Wei Xu,Tong Wang,Chuangang Gu,Liang Ding

DOI: https://doi.org/10.1115/gt2011-46167

2012-01-01

Abstract:The holed casing treatment is a new type of casing treatment with self-adaptability for centrifugal compressor with unshrouded impellers. It is demonstrated experimentally and numerically that both of the stall margin and the choked margin of the compressor can be expanded by the treatment. Numerical results indicate that there is a reinjected flow in the holes when the compressor works at low flowrate conditions and a bypass flow at high flowrate conditions. Hole’s diameter is an important parameter for the holed casing treatment. Five cases of different diameter (1.0mm, 1.5mm, 2.0mm, 2.5mm and 3.0mm) were carried out to reveal its influence. Both the stall margin and efficiency are improving with increasing of the hole’s diameter in the cases of diameter below than 2.5mm. At diameter of 2.5mm, the stall margin increment and the efficiency of the compressor are the highest among all 5 cases. However, in the case of 3.0mm, the stable working range enhancing as well as the efficiency is weakened because the velocity magnitude of the reinjected flow decreases. Therefore a key principle of choosing the diameter and the radial position of the hole is presented in the paper to get the best self-adaptive effect: enhancing stable running range as much as possible and keeping higher efficiency.