Abstract:Experimental facilities for aeroacoustic tests can contain large apparatus and supporting structures. This can impair the design and/or installation of an acoustic beamforming array that requires significant space and, in most cases, a clear line of sight between the array and the acoustic source. To alleviate this issue, previous studies have populated portions of spiral-based arrays over usable areas to best utilize the available space. This paper aims to numerically compare the performance of this array design method with a recently published method, called the Adaptive Array Reduction Method (AARM). The AARM simulates a large initial array and iteratively reduces the array to a desired number of channels by removing the channel based on sidelobe and main lobe criteria. The AARM and a spiral-based array design method were applied to a hypothetical room containing several obstructions, and a non-square area at NASA Langley Low-Turbulence Pressure Tunnel. In both cases the AARM outperformed the spiral-based array designs in terms of main lobe width and maximum sidelobe level and in some cases the main lobe distortion. To experimentally verify the design of AARM arrays over irregular areas, experiments were conducted at the Southern University of Science and Technology in an anechoic wind tunnel, using both a speaker source in zero-flow conditions and a NACA 0012 airfoil placed in uniform flow. The performance of the AARM arrays created over irregular areas were compared against an AARM array designed over a square area, revealing little to no decrease in performance in terms of source localization and sidelobe distributions in the source maps. The AARM has been shown both numerically and experimentally to be a suitable method for designing acoustic beamforming arrays in a spatially restricted experimental facility.

Localization of Acoustic Sources in an Enclosed Space by Double Layer Beamforming Array

Research on a high-resolution spherical beamforming algorithm for sound source localization

A Novel Acoustic Emission Beamforming Method with Two Uniform Linear Arrays on Plate-Like Structures.

Multi-Frequency Transmitting Beamforming Algorithm Based on Cross Array

Achieving 3D Beamforming by Non-Synchronous Microphone Array Measurements

2D passive localization of broadband sources with a small volume array

An adaptive localization method of simultaneous two acoustic emission sources based on energy filtering algorithm for coupled array signal

Spherical Reverse Beamforming for Sound Source Localization Based on the Inverse Method

Experimental Research on Cylindrical Focused Beamforming Localization Method of Moving Sound Sources Based on Vector Sensor Array

An Acoustic Beamforming Array Design Method for Spatially Restricted Experimental Facilities

Combined Method Of Near Field Acoustic Holography And Focused Beamforming For Noise Source Identification In Enclosed Space

The Source Localization Technique Based on Improved Functional Beamforming Using a Virtual Array

A High-Resolution and Low-Frequency Acoustic Beamforming Based on Bayesian Inference and Non-Synchronous Measurements

Passive wideband source localization based on cylindrical focused beamforming in shallow water

A Full Band Acoustic Beamforming Method in an Infinite Duct by the Corrected Pressure Measurement

Near-Field Beamforming Performance Analysis for Acoustic Emission Source Localization Based on Finite Element Simulation

Extrapolated Open Spherical Microphone Arrays Beamforming for Acoustic Source Localization

Localization of Low-Frequency Coherent Sound Sources with Compressive Beamforming-Based Passive Synthetic Aperture.

Leakage Source Localization Method for Aerospace Composite Structures Based on U-Array Wave Velocity-Compensated Beamforming

Localizing Two Acoustic Emission Sources Simultaneously Using Beamforming and Singular Value Decomposition

Adaptive Beamforming and Particle Filtering.