Abstract:Phase change emulsions are promising thermal fluids, but have been frustrated by high degrees of supercooling. The existing methods for supercooling reduction involve the addition of various nucleating agents (NAs) but have achieved limited success due to the lack of commonality and the negative impact on emulsion stability. This study explored a strategy by integrating interface-induced and NA-induced nucleation. A diblock copolymer was positioned at the interface and a new NA, polyethylene, was efficiently embedded into the droplets assisted by ultrasonication to minimize supercooling and extend stability. Firstly, hexadecane emulsion was chosen for assessment of the chemical compositions and ultrasonication conditions. A higher ultrasound intensity facilitated the polyethylene embedment, providing sufficient nucleation sites within the droplets with a low mass content (1 %). The functionality of polyethylene was found to be size-dependent, resulting in a single melting/freezing peak and a low supercooling degree ( ΔT ) of 3.7 °C for hexadecane droplets of 256.3 nm average diameter. Subsequently, the effectiveness of polyethylene was evaluated on other seven paraffin emulsions with higher melting points ( T m ), achieving minimal supercooling ( ΔT = 0.2–2.6 °C). Furthermore, dynamic stability was evaluated by applying an emulsion template ( T m ≈ 54 °C) to a rig for long period and repeated thermal cycles (6 months and 9000 cycles). The average diameter increased marginally from 374.1 to 393.4 nm, while the ΔT remained stable at 2.5 °C, and the latent heat slightly decreased. No obvious sign of emulsion breakdown was observed during an additional six-month storage period. An effective strategy has been developed for formulating a range of novel phase change emulsions with extended service life and minimal supercooling which are desirable for thermal energy storage applications.

The Thermal Performance of A Novel Phase Change Emulsion

Preparation, Property and Application of Phase Change Material Emulsions

Preparation and Characterization of Phase Change Microcapsule Emulsion for Thermal Energy Storage and Transportation

Thermophysical properties and thermal characteristics of phase change emulsion for thermal energy storage media

Thermophysical Properties of a Novel Nanoencapsulated Phase Change Material

A New Model of Phase Change Process for Thermal Energy Storage

Investigation on the Influence of Dispersion Mass Transfer on the Thermal Characteristics of Phase Change Emulsion

Experimental study on heat capacity of paraffin/water phase change emulsion

Development and thermal characteristics of phase change nanoemulsions for low-temperature thermal energy storage

Characteristics of OP35E-based phase-change emulsion and its potential applications in thermal management

Developing novel high-performance polyethylene-embedded phase change emulsions with minimal supercooling for efficient thermal energy storage

Experimental analysis of a low cost phase change material emulsion for its use as thermal storage system

Thermal Physical Properties and Key Influence Factors of Phase Change Emulsion

Preparation and Characterization of Nano-Sized Phase Change Emulsions As Thermal Energy Storage and Transport Media

Preparation and flow characteristic of a novel phase change fluid for latent heat transfer

Basic Physics and In-tube Resistances of Novel Phase Change Fluids

Investigation on the Heat Transfer and Charge/discharge Performance of Phase Change Material Capsule Emulsion Based on Nanoparticles Enhanced Thermal Conductivity

Thermodynamic Analysis of Photovoltaic/thermal Heat Pump Based on Phase Change Slurry

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Preparation, physical property and thermal physical property of phase change microcapsule slurry and phase change emulsion

Heat transfer performance of a phase-change material in a rectangular shell-tube energy storage tank