Abstract:Compared with simply supported beams, continuous steel-concrete composite beams have many advantages such as higher span/depth ratio, less deflection, and higher fundamental frequency of vibration due to its higher stiffness. However, in negative bending regions near interior supports, tension in concrete is unfavorable and a complicated issue, which deserves a special study. In this paper, a mechanics model based on elastic theory was established to investigate the stiffness of composite beams in negative bending regions by considering slips at the steel beam-concrete slab interface and concrete-reinforcement interface. In order to validate this approach, a test of three composite beams with profiled sheeting under negative bending was conducted. Meanwhile, a three-dimensional nonlinear finite element (FE) analysis was conducted to investigate the general behavior of the tested specimens. In addition, a comparative analysis between results derived from the analytical model, laboratory test, and FE analysis was performed. The results show that slip always exists for composite beams under negative bending even with complete shear connection (full composite action) between the steel and concrete components. The slip effect results in an additional curvature of beam bending and reduces the section stiffness by 10-20% compared with that of a beam without any slip in serviceability condition. This reduction should be considered in designing process especially for cantilever beams. Formulae under other loading cases and boundary conditions were also proposed. The results can serve as a basis for further study on stiffness of continuous steel-concrete composite beams and can directly be used for the deflection calculation of cantilever beams.

Characteristics of Bending Moment Redistribution and Changing Law with Load in Continuous Composite Beams

RESEARCH ON FLEXURAL PERFORMANCE OF DOUBLE-STEEL REINFORCED CONCRETE BEAM

Experimental Study on Moment Redistribution of Continuous Composite Steel-Concrete Beams with Profiled Sheeting

Bending Stiffness of Steel-Concrete Composite Beams Considering Effect of Slip

Internal Force Redistribution Caused by Cracking of Concrete in Composite Frame Structures under Lateral Load

LAW OF CRACK DEVELOPMENT AND CALCULATION OF CRACK WIDTH OF CONTINUOUS COMPOSITE BEAMS

Analytical And Numerical Modeling Of Prestressed Continuous Steel-Concrete Composite Beams

Analysis of Prestressing Load and Whole Mechanical Process of Externally Prestressed Continuous Composite Beams

Study on Mechanical Properties of Steel-Concrete Composite Beam with Corroded Studs Under the Effect of Negative Bending Moment

Experimental Study of Innovative Steel-Concrete Composite Beams under Hogging Moment

Long-Term Behavior of Composite Beams under Positive and Negative Bending. Ii: Analytical Study

Load Analysis on Asphalt Concrete Deck Pavement With Submodel Method

Experimental study of an innovative steel-concrete composite beam under hogging moment

Elastic analysis of composite beam with local-released combined action

Behavior of Steel–Concrete Composite Beams with Corroded Shear Studs under Negative Bending Moment

Deflection and Crack Calculation of Corroded Reinforced Concrete Beams

Deformation Analysis of Prestressed Continuous Steel-Concrete Composite Beams

Stiffness and Deflection of Steel–Concrete Composite Beams under Negative Bending

Test and Numerical Model of Curved Steel-Concrete Composite Box Beams under Positive Moments

Numerical study on the structural performance of the continuous concrete slabs reinforced with hybrid BFRP/steel bars

Analysis of Key Parameters of Non-Tension Prestressing Technology for Continuous Steel-Concrete Composite Beams