Abstract:Compared with simply supported beams, continuous steel-concrete composite beams have many advantages such as higher span/depth ratio, less deflection, and higher fundamental frequency of vibration due to its higher stiffness. However, in negative bending regions near interior supports, tension in concrete is unfavorable and a complicated issue, which deserves a special study. In this paper, a mechanics model based on elastic theory was established to investigate the stiffness of composite beams in negative bending regions by considering slips at the steel beam-concrete slab interface and concrete-reinforcement interface. In order to validate this approach, a test of three composite beams with profiled sheeting under negative bending was conducted. Meanwhile, a three-dimensional nonlinear finite element (FE) analysis was conducted to investigate the general behavior of the tested specimens. In addition, a comparative analysis between results derived from the analytical model, laboratory test, and FE analysis was performed. The results show that slip always exists for composite beams under negative bending even with complete shear connection (full composite action) between the steel and concrete components. The slip effect results in an additional curvature of beam bending and reduces the section stiffness by 10-20% compared with that of a beam without any slip in serviceability condition. This reduction should be considered in designing process especially for cantilever beams. Formulae under other loading cases and boundary conditions were also proposed. The results can serve as a basis for further study on stiffness of continuous steel-concrete composite beams and can directly be used for the deflection calculation of cantilever beams.

Elastic analysis of composite beam with local-released combined action

Experimental Study and Numerical Analysis of A Composite Bridge Structure

Reduced Stiffness of Composite Beams Considering Slip and Shear Deformation of Steel

Experimental Studies on Shear Strength of Steel–Concrete Composite Beams

Stiffness and Deflection of Steel–Concrete Composite Beams under Negative Bending

Analysis of Equivalent Flexural Stiffness of Steel–Concrete Composite Beams in Frame Structures

Experiment Analysis on Crack Resistance in Negative Moment Zone of Steel-Concrete Composite Continuous Girder Improved by Interfacial Slip

Study on the continuous composite beam with partial shear connection

Analysis of Mechanical Characteristics of Steel-Concrete Composite Flat Link Slab on Simply-Supported Beam Bridge

Structural behavior of steel-concrete composite slim beam in the negative moment region

Characteristics of Bending Moment Redistribution and Changing Law with Load in Continuous Composite Beams

Study on partial interaction effect of continuous composite beams

Nonlinear finite element analysis of beam-to-column composite connections in steel structures

Analysis of Shear Connector of Steel–Concrete Composite Box-Girder Bridge Considering Interfacial Bonding and Friction

Experimental and analytical research on the flexural behaviour of steel–ECC composite beams under negative bending moments

Analytical And Numerical Modeling Of Prestressed Continuous Steel-Concrete Composite Beams

Deformation Analysis of Prestressed Continuous Steel-Concrete Composite Beams

Analysis of Key Parameters of Non-Tension Prestressing Technology for Continuous Steel-Concrete Composite Beams

Structural performance of composite connections with a uniaxial symmetric steel-beam section

Experimental study of partially shear-connected composite beams with profiled sheeting

Fe Analysis Of Continuous Composite Beams With Partial Interaction