Abstract:Binder Jetting-Metal Additive Manufacturing (BJ-MAM) is a powder bed-based additive manufacturing technology which deposits liquid binder droplets to join powder particles to form complex shaped structures (i.e., green parts). As the printing process is done around room temperature, BJ-MAM is largely immune to the distortion and cracking issues that can be prevalent in melting based powder bed processes. However, a main issue for BJ-MAM is the part shrinkage and distortion during high-temperature sintering. The densification and deformation behaviors during pressureless sintering of green parts printed by BJ-MAM were studied in this paper. Experimentally, cantilever- and bridge-shaped coupons with varying beam lengths were printed using 316L stainless steel powder; these coupons produced different extents of deformation after sintering. Based on the existing modeling approaches in the powder metallurgy literature, a finite element model was developed incorporating an elastic-viscoplastic constitutive equation for computing both uniaxial equivalent creep strain and volumetric swelling strain. Two methods, a viscosity based and a power-law creep based, were further evaluated for calculating the uniaxial equivalent creep strain. Material property data used in the constitutive equation such as viscosity and creep parameters were collected from the literature, critically reviewed, and then inputted into the model. Other salient features of the model included thermal-mechanical property data that were dependent on both relative density and temperature as well as frictional contact between the part surface and the furnace wall under gravitational load. The calculated quantities such as shrinkage, final relative density, and deformed shapes were compared with the respective experimental data across different part geometries.

Plastic forming simulations of cold isostatic pressing of selective laser sintered components

Integrated Numerical Simulations and Experimental Measurements for the Sintering Process of Injection-Molded Ti-6Al-4V Alloy

Cold Isostatic Pressing to Improve the Mechanical Performance of Additively Manufactured Metallic Components

Numerical simulation and experimental analysis of solid-state sintering response of 316 L stainless steel micro-parts manufactured by metal injection molding

Numerical simulation and experimental measurement of pressureless sintering of stainless steel part printed by Binder Jetting Additive Manufacturing

Cold-isostatic pressing of metal powders: a review of the technology and recent developments

Development and characterisation of direct laser sintering Cu-based metal powder

Influence of different Processing Parameter on distortion and Residual Stress of Inconel 718 Alloys Fabricated by Selective Laser Melting (SLM)

Fabrication and Characterization of AISI 420 Stainless Steel Using Selective Laser Melting

Finite Element Analysis of Thermal Stress and Thermal Deformation in Typical Part during SLM

Numerical Simulation of Squeeze-Casting SiC3D/Al Ceramic Matrix Composites

Rapid prediction of the relationship between processing parameters and molten pool during selective laser melting of cobalt-chromium alloy powder: Simulation and experiment

Advances in Thermal Modeling of Selective Laser Sintering of Metal Powders

Crystal plasticity–based finite element modeling and experimental study for high strain rate microscale laser shock clinching of copper foil

Influence of hot isostatic pressing on microstructure, properties and deformability of selective laser melting TC4 alloy

Elasto-plastic residual stress analysis of selective laser sintered porous materials based on 3D-multilayer thermo-structural phase-field simulations

Computational study of rapid direct metal laser sintering for compression mold manufacturing

Capillary effects and consolidation kinetics during selective laser melting of 316L powder

Computational modelling and experimental validation of industrial forming processes by cold pressing of aluminum silicate powder

Elastoplastic coupling to model cold ceramic powder compaction