Abstract:Synthetic jets, known as zero-net mass-flux (ZNMF) devices, have been widely used for cooling electronics. A synthetic jet is generally composed of a cavity with an orifice on one side and an oscillating diagram on the other side. The vibration of the diaphragm will generate a periodically impinging flow through the orifice which is found to be effective in enhancing heat transfer. The thermal performance of the synthetic jet is highly dependent on the peak velocity of the synthetic jet is able to generate. The orifice shape, orifice thickness, and the number of the orifices are the factors which affect the vibration condition of the diaphragm and thus to affect the performance of the synthetic jet. This study will use both experimental and computational methods to find out the optimal design of synthetic jet and how these factors affect synthetic jet performance. The synthetic jet arrays are driven by a piezoelectric stack actuator which is vibrating at around 720 Hz and the mean-to-peak amplitude is around 0.2 mm. The jet diaphragm (120 mm × 15 mm) is designed using a composite structure composed of a carbon fiber beam, a carbon fiber frame, and a jet frame fabricated by polymethyl methacrylate (PMMA). Four different orifice shapes (square, single slot, double slot, and triangle) with the same area have been designed and the square orifice has the highest velocity. The effect of the orifice thickness is also studied by testing four kinds of PMMA films with different thicknesses (1.5 mm, 2 mm, 3 mm, and 4.5 mm) and the case with 4.5 mm thick orifice has the best performance. The numerical simulation is conducted using the CFD software ANSYS Fluent to support the experimental results. The vibrating of the diaphragm is defined as a moving wall using a user defined function. The fluid power consumed by the diaphragm is used to determine the performances of different designs. The same trend with orifice thickness has been found and the reason has been demonstrated.

Structural Parameters Optimization of Piezoelectric Micro Synthetic Jet Actuators

A Dynamic Piezoelectric Micropumping Phenomenon

Research and Fabrication of a Low-Cost Valveless Micropump Based on Piezoelectric Actuation

Piezoelectric Synthetic Jet Integrated with Heat Sink for Heat Transfer Enhancement

Effects of piezoelectric synthetic jet actuator parameters on synthetic jet formation process and actuator performance

Design and analysis of synthetic jet actuated by piezoelectric actuator

Numerical Investigation of Effect of Structural Parameters on the Performance of a Combustion-Driven Sparkjet Actuator

Influence of input signal on injection performance for needle driven piezoelectric micro-jet device

A new hysteresis modeling and optimization for piezoelectric actuators based on asymmetric Prandtl-Ishlinskii model

Design of high-power synthetic jet actuator and its flowfield investigation

Design Optimization of a Dual Function Piezoelectric Actuator

Influences of Excitation on Dynamic Characteristics of Piezoelectric Micro-Jets

Experimental research on dynamic characteristics of synthetic jet induced by SJA with HCPCS membrane

Optimization of Sensing and Feedback Control for Vibration/Flutter of Rotating Disk by PZT Actuators Via Air Coupled Pressure

Emulation and Experiment of Piezoeletric Micro Airflow Jet

Vibration And Jet-Stream Of A Piezoelectric Circular Plate Actuator

Research on a New Driving Membrane for Piezoelectric Synthetic Jet Actuator

Multi-parameter optimization of piezoelectric actuators for multi-mode active vibration control of cylindrical shells

Effects of Air on Enclosure Design of Lead-Zirconate-Titanate (pzt) Thin-Film Diaphragm Microactuators

A Polymeric Piezoelectric Synthetic Jet For Electronic Cooling

Concurrent topology optimization of multiscale piezoelectric actuators