Abstract:This paper investigates the possibility of developing a new method for fault detection of a damper in the primary suspension of the railway vehicle, based on the analysis of the vertical vibration’s response of the bogie. To this purpose, experimental data are used, along with results from numerical simulations regarding the Root Mean Square (RMS) accelerations measured/simulated in four reference bogie points—two points on the chassis, against the suspension, and two points located against the axle boxes. The experimental data are utilized to define the normal area of operating and the damper failure area in the bogie primary suspension, as well as a basis for validating the results of numerical simulations. The numerical simulations are developed on the basis of two original models of the vehicle–track system, rigid-flexible coupled type, which take into account the elasticity of the vehicle carbody and the elasticity of the wheel-rail contact: a reference model with 15 degrees of freedom, for simulating the bogie response to vertical vibrations for the normal operating of the primary suspension dampers, and an extended model with 20 degrees of freedom, for simulating the bogie vibration response to the failure damper of a primary suspension. The presented results show that there are clear premises on the possibilities of developing a fault detection method of any of the four dampers of the primary suspension corresponding to a vehicle bogie, based on the RMS accelerations measured only in two reference points of the bogie.

Fault Diagnosis of Rail Vehicle Suspension Systems by Using Glrt

Fault isolation of rail vehicle suspension systems by using similarity measure

Research on Fault Detection and Isolation of Railway Vehicle Suspension System by Impulse Track Irregularity

Condition monitoring for train suspension system based on cross-correlation

A Deep-LSTM-Based Fault Detection Method for Railway Vehicle Suspensions

ToMFIR-based incipient fault detection and estimation for high-speed rail vehicle suspension system

A condition monitoring approach for the detection of defects in the primary suspension of railway vehicles

Component-Level Fault Detection for Suspension System of Maglev Trains Based on Autocorrelation Length and Stable Kernel Representation

A Diagnosis Scheme for Intermittent Faults in Active Suspension Systems of High Speed Trains

Condition Monitoring of the Dampers in the Railway Vehicle Suspension Based on the Vibrations Response Analysis of the Bogie

Study of Fault Diagnosis Method for Train Control System

Design of Onboard Device to Diagnose Track Fault Online

Detection Method Based on Kalman Filter for High Speed Rail Defect AE Signal on Wheel-Rail Rolling Rig

Maglev Train Suspension Control Failure Diagnosis Method Based on Steady Estimator of General Parameters

A Review on Fault Diagnosis for Rail Vehicles

Sensor fault detection of vehicle suspension systems based on transmissibility operators and Neyman–Pearson test

Train suspension system fault diagnosis and fault-tolerant control method based on dynamic actuator

Suspension system state estimation using adaptive Kalman filtering based on road classification

Research on fault diagnosis of electromagnetic active suspension based on double observer intelligent switching

Review of Fault-Tolerant Control Methods for Suspension Systems: From Road Vehicles to Maglev Trains

Estimation of the Parameters of A Railway Vehicle Suspension Using Model-Based Filters with Uncertainties