Abstract:We propose a blood separation microfluidic device suitable for point-of-care (POC) applications. By utilizing the high gas permeability of polydimethylsiloxane (PDMS) and phaseguide structures, a simple blood separation device is presented. The device consists of two main parts. A separation chamber with the phaseguide structures, where a sample inlet, a tape-sealed outlet, and a dead-end ring channel are connected, and pneumatic chambers, in which manually operating syringes are plugged. The separation chamber and pneumatic chambers are isolated by a thin PDMS wall. By manually pulling out the plunger of the syringe, a negative pressure is instantaneously generated inside the pneumatic chamber. Due to the gas diffusion from the separation chamber to the neighboring pneumatic chamber through the thin permeable PDMS wall, low pressure can be generated, and then the whole blood at the sample inlets starts to be drawn into the separation chamber and separated through the phaseguide structures. Reversely, after removing the tape at the outlet and manually pushing in the plunger of the syringe, a positive pressure will be created which will cause the air to diffuse back into the ring channel, and therefore allow the separated plasma to be recovered at the outlet on demand. In this paper, we focused on the study of the plasma separation and associated design parameters, such as the PDMS wall thickness, the air permeable overlap area between the separation and pneumatic chambers, and the geometry of the phase-guides. The device required only 2 mu l of whole blood but yielding approximately 0.38 mu l of separated plasma within 12 min. Without any of the requirements of sophisticated equipment or dilution techniques, we can not only separate the plasma from the whole blood for on-chip analysis but also can push out only the separated plasma to the outlet for off-chip analysis. (c) 2015 AIP Publishing LLC.

High-efficiency blood separation utilizing spiral filtration microchannel with gradually varied width

Continuous blood separation utilizing spiral filtration microchannel with gradually varied width and micro-pillar array

Separation of blood on a chip utilizing spiral micorchannel with fence and cofferdam as filtration structures

Blood Plasma Separation Microfluidic Chip with Gradual Filtration

Numerical Design of a Highly Efficient Microfluidic Chip for Blood Plasma Separation

A plasma separation device based on centrifugal effect and Zweifach-Fung effect

Highly Efficient Plasma Separation on Centrifugal Microfluidic Platform

Multi-component Continuous Separation Chip Composed of Micropillar Arrays in a Split-Level Spiral Channel

Dean vortex-enhanced blood plasma separation in self-driven spiral microchannel flow with cross-flow microfilters

Separation of Blood Plasma by Inertial Focusing Using Microfluidic Chips

A Microfluidic Chip for Blood Plasma Separation Using Electro-Osmotic Flow Control

Microfluidic Chip for Blood Cell Separation and Collection Based on Crossflow Filtration

Blood component separation in straight microfluidic channels

A cylindrical microfluidic centrifuge for high-efficient blood separation

Design and Fabrication of a High Performance Microfluidic Chip for Blood Plasma Separation: Modelling and Prediction of System Behaviour via CFD Method

High-throughput and Clogging-Free Microfluidic Filtration Platform for On-Chip Cell Separation from Undiluted Whole Blood.

High-Throughput Blood Plasma Extraction in a Dimension-Confined Double-Spiral Channel

Microfluidic Cell Separation Chips Based on Crossflow Filtration

Microchannel with Stacked Microbeads for Separation of Plasma from Whole Blood

Phaseguide-assisted blood separation microfluidic device for point-of-care applications.

Ultrahigh Throughput Beehive‐like Device for Blood Plasma Separation