Abstract:The direct analysis of solid samples using electrothermal (graphite furnace) atomic absorption spectrometry (ETAAS) has been investigated for the determination of thallium in river and marine sediment reference materials, because complete digestion of sediment samples requires the use of hydrofluoric acid and/or an alkaline fusion, and the extraction with aqua regia might be incomplete and cause interferences in the determination of thallium. The determination of thallium in river sediments using direct solid sampling ETAAS was straight forward, and could be carried out with good accuracy even without the use of a chemical modifier or calibration against aqueous standards. The analysis of marine sediments, in contrast, proved to be extremely difficult due to severe spectral and non-spectral interferences. The latter ones were caused by the relatively high chloride content of marine sediments, compared to river sediments, and could eventually be controlled by the addition of ammonium nitrate as a chemical modifier together with ruthenium as a permanent modifier. The spectral interference could only be overcome with Zeeman-effect background correction, and was most likely caused by sulfate. After optimization of the procedure, thallium in marine sediment reference materials could be determined by calibration against a certified river sediment reference material. According to the experience gained with river sediments, it might be assumed that aqueous standards could equally be used for calibration; this approach, however, was not further investigated. The results were in good agreement with non-certified ‘information’ values for thallium and with results obtained by ICP-MS using electrothermal vaporization and isotope dilution calibration. A characteristic mass of 13 pg was obtained, and the limit of detection of the proposed method, based on the zero-mass response (three times the standard deviation of 10 atomization cycles with empty platforms), was around 0.02 µg g−1 Tl.

Selective Solid-Phase Extraction of Trace Thallium with Nano-Al2o3 from Environmental Samples

Simultaneous Separation and Determination of Thallium in Water Samples by High-Performance Liquid Chromatography with Inductively Coupled Plasma Mass Spectrometry

A Sequential Injection On-Line Column Preconcentration System for Electrothermal AAS Determination of Thallium in Geochemical Samples

Removal of Thallium from Aqueous Solutions by Adsorption onto Alumina Nanoparticles

Control of spectral and non-spectral interferences in the determination of thallium in river and marine sediments using solid sampling electrothermal atomic absorption spectrometry

Selective removal of thallium from water by MnO2-doped magnetic beads: Performance and mechanism study

Efficient Sorption of Th(IV) from Aqueous Solutions Onto Magnetic Chitosan Nano-Particles Functionalized with Alanine and Valine

Selective separation and enrichment of trace Au(Ⅲ) and Pd(Ⅳ) with poly-allylthiourea sorbent

Preconcentration of Trace Aluminum (III) Ion Using a Nanometer-Sized TiO2-silica Composite Modified with 4-Aminophenylarsonic Acid, and Its Determination by ICP-OES

In Situ Measurement of Thallium in Natural Waters by a Technique Based on Diffusive Gradients in Thin Films Containing a Δ-Mno2 Gel Layer.

Selective solid phase extraction of trace Sc(III) from environmental samples using silica gel modified with 4-(2-morinyldiazenyl)-N-(3-(trimethylsilyl)propyl)benzamide.

Ratiometric Phosphorescent Probe for Thallium in Serum, Water, and Soil Samples Based on Long-Lived, Spectrally-Resolved Mn-doped ZnSe Quantum Dots and Carbon Dots.

Determination of trace thallium by flow injection combined with graphite furnace atomic absorption spectrometer based on immobilized p -dimethylaminobenzylidenerhodanine separation and preconcentration

The determination of thallium in the environment: A review of conventional and advanced techniques and applications

Selective solid-phase extraction using oxidized activated carbon modified with triethylenetetramine for preconcentration of metal ions

Treatment on Containing Thallium Wastewater by ECS Activation and Adsorption Purification of Microporous Materials

Fabrication and characterization of magnetically responsive Fe3O4@TiO2 core-shell adsorbent for enhanced thallium removal

Selective Capture of Thallium(i) Ion from Aqueous Solutions by Amorphous Hydrous Manganese Dioxide

Effective Removal of Trace Thallium from Surface Water by Nanosized Manganese Dioxide Enhanced Quartz Sand Filtration.

Highly Efficient Removal of Trace Thallium from Contaminated Source Waters with Ferrate: Role of in Situ Formed Ferric Nanoparticle.

In-situ pre-concentration through repeated sampling and pyrolysis for ultrasensitive determination of thallium in drinking water by electrothermal atomic absorption spectrometry.