Abstract:P-doped TiO2 nanoparticles were synthesized by the sol-gel method with various H3PO4 amounts. The samples were calcinated at different temperature and charactered by XPS, ICP, XRD, SEM, Raman, FTIR, and UV-vis methods, so that the formation process of phosphate species could be inspected. The XRD results show that P species hinder the particle growth of anatase and increase the anatase-to-rutile phase transformation temperature to more than 900 degrees C, and a new titanyl phosphate, Ti5O4(PO4)(4), was observed in P-doped TiO2 when calcined at 1000 degrees C. The UV-vis results indicate that the P species is likely to have two different states, leading to the variety of visible-light photocatalytic activity and band gap energy of P-doped TiO2. One state is the "separated phase". In this state, the P/Ti ratio is very low so that the P species is surrounded by TiO2. The "separated phase" of P species introduces oxygen into TiO2 lattice and hence causes a red-shift of the adsorption band edge of anatase, leading to the increased visible-light photocatalytic activity of P-doped TiO2. The other state is the "congregated phase". It appears at the micro region where the ratio of P/Ti is high enough to make the TiO2 clusters isolated by P species. The "congregated phase" of P species acts as the interface phase between TiO2 clusters and strongly retards the crystal growth of anatase, resulting in the widened band gap of P-doped TiO2. Furthermore, a possible mechanism was also proposed to explain the formation of the two phases during the sol-gel process. The results indicate that in order to improve the visible-light photocatalytic activity of P-doped TiO2 the percentage of "separated phase" in P species needs to be enhanced.

Impurity Concentration Dependence of Optical Absorption for Phosphorus-Doped Anatase TiO2

Effect of the P/Ti Ratio on the Visible-Light Photocatalytic Activity of P-Doped Tio2

Influence of Fe2o3 Doping on Morphology and Photocatalytic Activity of Tio2 Prepared by Adsorption Phase Synthesis

State of Doped Phosphorus and Its Influence on the Physicochemical and Photocatalytic Properties of P-Doped Titania

Effect of Calcined Atmosphere on the Photocatalytic Activity of P-doped TiO2

First Principles Calculations of the Electronic Structure and Optical Properties of Pure and (nb, N) Co-Doped Anatase

First-principles Study on the Electronic and Optical Properties of F- and Nb-doped Anatase TiO2

Optimizing Photoelectrochemical Properties of Tio2 by Chemical Codoping

Study the High Photocatalytic Activity of Vanadium and Phosphorus Co-Doped TiO2 from Experiment and DFT Calculations

First-principles study of C-doped anatase TiO2

Role of Phosphorus in Synthesis of Phosphated Mesoporous TiO2 Photocatalytic Materials by EISA Method

TiO2 Band Restructuring by B and P Dopants

Synergistic effect of V/N-codoped anatase TiO2 photocatalysts

Photocatalytic properties of phosphor-doped titania nanoparticles

Influence of Zr–S Co-Doping on the Electronic Structure and Optical Properties of Anatase TiO2: First-Principles GGA + U Method

Electronic structure and optical properties of C-Pt codoped anatase TiO2 by first principles

Role of Titanium replacement with Pd atom on band gap reduction in the anatase Titanium Dioxide: First-Principles calculation approach

Anatase-Selective Photoluminescence Spectroscopy of P25 TiO2 Nanoparticles: Different Effects of Oxygen Adsorption on the Band Bending of Anatase

Correlation of Electronic Structures and Crystal Structures with Photocatalytic Properties of Various Doped TiO2

Modulating Impurity Levels in Two-Dimensional Polar Materials for Photocatalytic Overall Water Splitting

A DFT Study on the Modification Mechanism of (cr, C) Co-Doping for the Electronic and Optical Properties of Anatase TiO2